





INFRASTRUCTURE TEAM
+27 (0) 11 237 1000
Duplex LC to LC singlemode fibre patch lead
G657A2 bend-insensitive fibre, 3.0mm jacket, 3 metres
PVC/LSZH sheath in yellow
Fibre patch leads are the short cables that connect equipment in a structured network, and the Duplex LC/LC G657A2 3.0mm 3m lead is a singlemode example built for that job. It has an LC connector at both ends and two fibres in one cable, so it can carry data in both directions. The three-metre length suits connections between neighbouring pieces of equipment in a rack or between a rack and a nearby patch panel.
Singlemode fibre has a very small core, so light travels along one path. It is used for longer distances and higher bandwidth than multimode fibre, and it is identified by its yellow jacket by convention. G657A2 is a bend-insensitive version of singlemode fibre. Its design allows tighter bends than conventional singlemode fibre before the signal is affected. In practice this means the lead can be routed through tight spaces at the back of a cabinet, around cable managers and into trays without special handling, provided it is not bent sharper than the manufacturer recommends.
The PVC/LSZH jacket is a compromise between two materials. PVC is a common, flexible cable sheath. LSZH stands for low smoke, zero halogen. A cable with an LSZH sheath produces less smoke when it burns and does not release halogen gases, which is useful in enclosed or occupied buildings where smoke and toxic fumes are a concern. Your building or installation rules may specify a particular sheath type, so confirm this before choosing a lead.
Check that the connector type is LC at both ends and that the fibre is singlemode, as your transceivers and patch panels must match. Confirm the number of fibres needed for your link, since this lead is duplex with two fibres. Measure the route so that the three-metre length is sufficient without excessive slack or strain on the connectors. Keep the lead clean before connecting it, as dust on the end faces is a common cause of poor performance on fibre links.
Fibre leads should be handled with care. Do not kink the cable, pull it by the jacket beyond its rated load, or tie it tightly. Keep the connector end caps on until the lead is ready to be connected. Use a suitable cleaning method on the connector ferrules before plugging in. Route the lead so it is supported along its length, and leave gentle curves rather than sharp corners. Label both ends so the link is easy to trace later.
The Duplex LC/LC G657A2 3.0mm 3m yellow patch lead is a straightforward choice for short singlemode connections in a managed network. Its bend-insensitive fibre, LSZH-rated jacket and standard LC connectors make it suitable for a wide range of cabinet and room layouts.
Duplex LC to LC singlemode fibre patch lead
G657A2 bend-insensitive fibre, 3.0mm jacket, 3 metres
PVC/LSZH sheath in yellow
Share this on your favourite channel: