





INFRASTRUCTURE TEAM
+27 (0) 11 237 1000
Eaton
Gen2 maintenance bypass, 11000 VA
Hardwired input, (4) C39 outputs, rack-mounting kit included
The Eaton HotSwap MBP 11000i G2 is a Gen2 maintenance bypass module designed to work with the Eaton 9PX and SX G2 range of 8 to 11 kVA uninterruptible power supply systems. Rated at 11000 VA, it gives facilities teams a controlled way to isolate a UPS for servicing, repair or replacement while the connected load stays powered.
Power protection is only as good as the way it is maintained. Without a bypass, taking a UPS offline usually means shutting down the equipment it supplies. The HotSwap MBP 11000i G2 removes that problem by routing the load through a bypass path while the UPS is isolated, so IT and operations teams can plan maintenance around business hours rather than around equipment shutdowns.
Because the input is hardwired, the bypass is intended for a fixed installation rather than a plug-in connection. Installation should be carried out by a qualified electrician who can check the supply, the protective devices and the cabling against the requirements of your site. The included rack-mounting kit allows the unit to be fitted in a standard 19-inch rack, which keeps the bypass close to the UPS and simplifies the switching procedure.
A maintenance bypass is most valuable at the moment you need it. When a UPS needs a battery check, a firmware update, a fault investigation or a full replacement, the bypass lets the technician isolate the UPS while the load continues to run. This avoids unplanned downtime, reduces the risk of data loss from abrupt shutdowns and gives the service team a clear, documented route for taking the system offline and bringing it back.
The HotSwap MBP 11000i G2 suits environments where power interruptions carry a high cost, including:
Before ordering, check that your UPS is within the 8 to 11 kVA range covered by this bypass, and that the outlets and input arrangement match your installation. If you are unsure which UPS model you have, or whether your site needs a bypass with a different rating, speak to a power protection specialist first. Once the right unit is chosen, the included rack kit and clear hardwired connection make it straightforward to add to a well-organised rack.
The Eaton HotSwap MBP 11000i G2 is a practical addition for any site running an Eaton 9PX or SX G2 UPS in the 8 to 11 kVA range. It brings maintenance flexibility, reduces downtime and supports a safer, more predictable service routine for critical power infrastructure.
Eaton
Gen2 maintenance bypass, 11000 VA
Hardwired input, (4) C39 outputs, rack-mounting kit included
Share this on your favourite channel: