





INFRASTRUCTURE TEAM
+27 (0) 11 237 1000
MECER
42U, 800 x 1000 mm, black, perforated front door
Supplied with 4 uprights, 4 feet, gland plates and screws
The MECER ATL8042.PER.B is a black 19-inch floor-standing cabinet built to hold server, networking and data equipment in an organised, ventilated space. It belongs to the MECER ATL range of high-density server and data-centre cabinets, which is designed for heavier loads than a standard office network rack.
Model codes in this range follow a simple pattern. The code ATL8042.PER.B tells you the cabinet is 800 mm wide, 1000 mm deep and 42U high, with a perforated door (PER) and a black finish (B). Glass-door versions in the same range use the GLA code instead of PER.
Equipment in a network cabinet produces heat, and heat shortens the life of electronics. A perforated door lets air pass through the front of the cabinet, so air can flow in and out and the equipment inside can stay cooler. This is why perforated doors are often chosen for server rooms and for racks with active hardware. If you need to see your equipment or want more security against dust and casual access, a glass door version of the same cabinet is available in the range.
The four uprights form the frame that carries the rack-mounted equipment, and the four feet give the cabinet a stable base on the floor. The gland plates provide a tidy entry point for power and data cables, which helps keep the cable routing organised and reduces clutter around the cabinet. The screws needed for assembly come with the cabinet, so you do not need to source them separately.
Because the cabinet has 42 rack units, you can combine several types of equipment in one enclosure, such as switches at the top, servers in the middle and a patch panel near the bottom. Planning the layout before you install equipment makes it easier to manage cable runs and to add hardware later.
Place the cabinet on a level, firm floor and allow enough clearance at the front and back for airflow and for opening the door. Make sure there is a suitable power supply nearby for the equipment you plan to install. Route cables through the gland plates and use cable management accessories to keep the rear tidy. Check that the total weight of your equipment stays within the rated load of the cabinet.
This model is suited to IT managers, system integrators and installers who need a sturdy, ventilated 42U cabinet for server or network equipment. It is also useful for businesses that expect to grow their rack and want a cabinet with enough height and depth for future hardware.
MECER
42U, 800 x 1000 mm, black, perforated front door
Supplied with 4 uprights, 4 feet, gland plates and screws
Share this on your favourite channel: