





INFRASTRUCTURE TEAM
+27 (0) 11 237 1000
Molex
110 Wiring Block C6/6A, 64P, with legs and 16 IDC’s
Base block for Cat6 and Cat6A UTP termination

The Molex 110 Wiring Block C6/6A 64P is a base wiring block from the Molex 110 wiring series. It is built for structured copper cabling, where Category 6 and Category 6A unshielded twisted pair (UTP) cables are terminated and organised within a communications room or distribution point. In a typical installation, the block sits at the point where cables from the building are landed, giving technicians a clear and consistent place to connect, label and manage each circuit.
The Molex 110 system is widely used in structured cabling because it keeps termination work orderly. Instead of loose cable ends hanging from a rack or wall, the wiring block provides a fixed, organised layout that is easier to test, maintain and extend. This particular unit is the C6/6A variant, which means it is designed for the higher-performance copper cabling used in modern office and data networks.
This wiring block is supplied with the following features, as listed in the supplier description and product details:
The IDCs are the part of the block that does the actual connection work. When an installer presses a conductor into an IDC, a sharp contact cuts through the wire insulation and forms a secure electrical connection with the copper core. This method avoids the need to strip and wrap each wire separately, which can speed up installation and reduce the chance of inconsistent terminations. Because the IDCs are part of the block design, the quality of each termination depends on following the correct cable preparation and punch-down process.
Many 110 blocks are mounted to a backboard or panel, but a version with legs can be placed on a flat surface, such as a shelf, a cabinet base or a floor-standing frame. This is useful where wall space is limited or where the installer needs to work on the block from several sides. The legs help the block sit steadily while cables are routed and terminated, although the exact mounting arrangement should be planned to suit the site.
Before ordering, it helps to confirm the rest of the 110 system. Check that your cable type, termination tools, connecting blocks, cable management and labelling materials are compatible with the Molex 110 range. Cabling that is intended for Category 6A should also be installed and terminated with care, because the performance of the whole link depends on the quality of each connection.
The price list entry does not include full dimensions, materials, mounting details or performance figures. For these, refer to the Molex datasheet for the product. Your installer or network designer can then confirm that the block suits the layout, the number of pairs and the expected cable runs for your project.
The Molex 110 Wiring Block C6/6A 64P with Legs and 16 IDCs is a practical termination block for organised copper cabling. It suits technicians who need a reliable point to land Cat6 or Cat6A UTP cables, with legs for flexible placement and IDCs for secure conductor termination.
Molex
110 Wiring Block C6/6A, 64P, with legs and 16 IDC’s
Base block for Cat6 and Cat6A UTP termination
Share this on your favourite channel: