





INFRASTRUCTURE TEAM
+27 (0) 11 237 1000
MOLEX
96-fibre singlemode fibre optic cable, external use
G562.D specification, black PE outer sheath
The Molex 96F LT CST EXT SM G562.D PE Black is a high-count singlemode fibre optic cable designed for backbone and campus structured cabling. With 96 fibres in a single cable, it gives installers a large amount of capacity in one run, reducing the number of cables that must be pulled between buildings, equipment rooms and distribution points.
The part number is taken from Molex’s CST double-sheath offering for singlemode cable. This range is listed in Molex’s structured-cabling datasheets alongside the company’s copper patch panels, DataGate modules and fibre enclosures, so the cable is intended to form part of a complete Molex fibre solution.
Singlemode fibre has a very small core, which allows light to travel along a single path. This keeps signal loss and dispersion low over long distances. Singlemode is therefore the usual choice when a link must cover kilometres rather than metres, or when a network needs to carry very high data rates over a long backbone.
The black PE sheath is a polyethylene jacket. Polyethylene resists moisture and is commonly used for outdoor and underground cable routes, where the cable is exposed to water, temperature changes and mechanical stress. The EXT designation in the part number indicates that the cable is intended for external use, but the installation environment and method should always be confirmed against the Molex datasheet.
Fibre cable of this type should be handled with care. Observe the minimum bend radius, avoid excessive pulling tension, and protect the cable where it enters buildings or runs through ducts. Terminations are usually made in fibre enclosures, splice trays or cassettes, using Molex fibre componentry that matches the fibre type. Splicing and testing should be carried out by trained installers, and the completed link should be tested and documented before handover.
Before ordering, confirm the required fibre count, sheath type and installation route, and check the Molex datasheet for the full mechanical and optical specifications. Matching enclosures, patch leads and connectors should be selected from the same Molex range wherever possible to keep the link within the manufacturer’s performance parameters.
In short, the Molex 96F LT CST EXT SM G562.D PE Black is a high-capacity singlemode fibre cable for installers who need a robust, outdoor-rated backbone solution with plenty of fibres in one run.
MOLEX
96-fibre singlemode fibre optic cable, external use
G562.D specification, black PE outer sheath
Share this on your favourite channel: