





INFRASTRUCTURE TEAM
+27 (0) 11 237 1000
Molex
Cat6 UTP LSOH patch cord, 2m, grey, 568A/B wiring
Ideal for connecting patch panels to network outlets and switches
The Molex Cat6 UTP LSOH patch cord in grey, 2 metres long, is a ready-made copper lead for structured network cabling. It belongs to the Molex Cat6 patch lead range and is intended for making the short connections that tie a cabling system together, from patch panel to active equipment.
Patch cords are the everyday working parts of a network. Every time a switch port, a patch panel, or a wall outlet needs to be connected, a patch lead is used. Choosing a consistent, well-made cord helps keep the installation tidy and easy to trace, and a colour such as grey can be used to separate one function from another across the rack.
LSOH stands for low smoke zero halogen. The outer jacket is made from a material that produces little smoke and no halogen gases when burned. This is a common requirement in buildings where people gather or where electronic equipment is concentrated, because it reduces the hazards during a fire. Always confirm local building and fire regulations when selecting cabling for a project.
568A and 568B are the two standard pin-out schemes defined for RJ45 terminations. Both are valid, but they are wired in a different order. The key rule is to use the same scheme at both ends of a cord, which is what straight-through patch leads are designed to do. The 568A/B designation on this lead indicates that it is supplied in line with those standard terminations, which helps when it is installed alongside other components wired to the same standard.
Category 6 is a widely used copper standard for office and campus networks. Patch leads should match or exceed the performance of the horizontal cabling they connect to, so using Cat6 patch cords alongside Cat6 cabling and Cat6 panels keeps the channel consistent. Mixing categories can create weak links that are hard to diagnose later.
Keep patch leads as short as practical so that cable management stays clean. Route them with cable managers rather than letting them hang loose, and avoid tight bends or pinching when fitting them into trunking or panel frames. Label both ends to make future work faster. Where a cord crosses a power cable, keep the separation recommended by the installer or local cabling practice.
This patch cord suits installers, IT teams, and facilities managers who need a dependable 2 metre Cat6 copper lead in a neutral grey colour. Its LSOH sheath makes it a sensible choice for indoor cabling where fire-safety performance is a priority. For longer runs, outdoor installations, or different performance requirements, check the relevant Molex datasheet and the length options in the wider patch cord range.
Molex
Cat6 UTP LSOH patch cord, 2m, grey, 568A/B wiring
Ideal for connecting patch panels to network outlets and switches
Share this on your favourite channel: