





INFRASTRUCTURE TEAM
+27 (0) 11 237 1000
Molex
Cat6A shielded LS0H patch cord, 568A/B wiring, 20m length, grey
The Molex Cat6A Shielded LS0H Patch Cord is a 20 metre grey patch lead designed for connecting equipment in structured cabling installations. Part of the Molex Cat6A range of shielded products, it is intended for network environments that need dependable copper connections at Cat6A performance levels, with the screening and sheath needed in busier or more demanding buildings.
Patch cords like this one form the final link between a fixed cabling outlet or patch panel and the active equipment it serves, such as a switch, router, server, workstation or access point. Because the lead is a full 20 metres long, it is suited to runs where the equipment sits well away from the panel, so it can be used without needing to coil excess cable.
Category 6A is designed for 10 gigabit Ethernet over standard copper cabling, and the Cat6A specification allows that speed over the full 100 metre channel length. The shielding helps reduce electromagnetic interference from nearby power cables, lighting and electrical equipment, which is useful in plant rooms, offices with many electrical devices, and buildings where cables share trays or ducts with power wiring. A shielded lead should always be used with shielded components, so the link stays continuous from the outlet through to the equipment.
LS0H stands for low smoke, zero halogen. If cables are exposed to fire or extreme heat, an LS0H sheath produces much less smoke than standard PVC, and it does not release halogen gases that create toxic or corrosive fumes. For this reason LS0H cables are often specified for hospitals, schools, public buildings, data centres and offices where people and equipment must be protected in the event of a fire.
The cord is wired to the 568A/B standards, which are the two wiring schemes recognised for RJ45 terminations. Keeping both ends to the same scheme ensures that the pairs are connected correctly and that the lead works as a straight-through patch cord. Installers should check that the colour code matches the rest of the system before connecting.
A 20 metre lead is useful when the equipment is far from the patch panel, but it can also leave a lot of slack if it is used in a short run. Measure the route before ordering, allowing for the path along trays and walls and for the height of the cabinet. Shorter leads are easier to manage in tight cabinets, while longer leads give flexibility during future changes.
Avoid bending the cable tighter than its recommended radius, and do not pull it hard during installation. Use cable management bars and tidy the slack neatly to keep airflow open in the cabinet. Label both ends clearly so that the connection can be traced in the future. Keep patch cords away from sources of heavy electrical interference where possible, and test each link after installation.
The Molex Cat6A Shielded LS0H Patch Cord in grey is a practical choice for anyone building or upgrading a structured network that needs a longer, shielded and safe copper link.
Molex
Cat6A shielded LS0H patch cord, 568A/B wiring, 20m length, grey
Share this on your favourite channel: