





INFRASTRUCTURE TEAM
+27 (0) 11 237 1000
Molex
Cat6A U/FTP solid cable patch cord assembly, LS0H sheath, 8 m
Part number PCD-07308-VL-D
The Molex Cat6A U/FTP solid cable patch cord assembly, part number PCD-07308-VL-D, is an 8 metre copper network cable assembly made for structured cabling installations. It combines Category 6A performance with U/FTP construction and an LS0H sheath. Assemblies of this type are used where a fixed copper link needs to be made quickly and neatly between a outlet, panel or consolidation point and the equipment it serves.
Structured cabling is the backbone of a building’s network. It consists of fixed installed cable runs, outlets, patch panels and short leads that connect everything together. Rather than running a loose cable from every device back to a central point, installers use standard components that can be added, moved and documented over time. This assembly is one of those components, and it is designed to fit into a Molex system alongside outlets, modules and panels from the same family.
The assembly is a solid-conductor copper cable with a factory-made termination configuration described on the supplier listing as a consolidation drop style assembly. Solid conductors are stiffer than stranded ones and are normally chosen for fixed, permanent routing. The U/FTP construction means the four twisted pairs are not individually screened, while an overall foil screen wraps the bundle to help control interference from outside sources.
Category 6A is a step up from Category 6 and is designed to support demanding network traffic over copper. Organisations that expect to grow their bandwidth needs, or that run many devices in one area, often specify Category 6A so that the cabling will remain useful as equipment is upgraded. Choosing the right category for the whole link is important, because the performance of the entire channel is limited by its weakest component.
LS0H stands for low smoke, zero halogen. Cable sheaths with this rating produce less smoke and no halogen gases when they burn, which is helpful in enclosed spaces where people gather, in ceilings and in plenum-type areas. Many building specifications ask for this type of sheath, so it is worth confirming that your project requires it before ordering.
Measure the route before you order. An 8 metre assembly leaves room for slack, but long paths through trunking or around obstacles may need careful planning. Keep cables away from strong power sources where possible, and avoid sharp bends or excessive pulling, which can damage the twisted pairs. Label both ends clearly so that the link can be identified during maintenance or future changes.
Before buying, confirm the connector style, sheath colour and length required by your installation drawings. Check the part number against the Molex datasheet to make sure the assembly matches the performance and environmental ratings your project needs. If you are unsure which Molex component fits your design, speak to your supplier or a structured cabling specialist.
Molex
Cat6A U/FTP solid cable patch cord assembly, LS0H sheath, 8 m
Part number PCD-07308-VL-D
Share this on your favourite channel: