





INFRASTRUCTURE TEAM
+27 (0) 11 237 1000
Molex
Field-terminated CAT6A RJ45 plug
Part code KSP-00001

The Molex Field Terminated Plug CAT6A RJ45 is a copper connector for installers who terminate Category 6A cabling on site. Rather than buying a fixed-length patch lead, the installer fits this plug to a cable run and sizes the run to the exact distance required. It belongs to the Molex field-terminable RJ45 (MPTL) Cat 6A range within the wider Molex structured-cabling family.
Pre-made patch leads come in set lengths, so installers often hold stock in several sizes or cut more cable than needed. A field-terminated plug removes that compromise. The installer cuts cable to the precise route length, fits the plug, and tests the link. This approach is common in new builds and refurbishments where distances vary from one outlet to the next.
This plug is most useful in structured network cabling projects. Common applications include office floors where each workstation needs a custom-length link to a patch panel, school and university computer labs, hospital and clinic data networks, and commercial buildings with high-speed backbone and horizontal cabling. It can also support repairs, where a damaged end must be replaced without replacing the whole cable run.
A field-terminated plug is only as good as its termination. Installers should strip the outer jacket to the correct length, untwist the pairs only as far as the plug design allows, and seat each conductor in the order the manufacturer specifies. Use the correct crimping or termination tool and check the finished link with a certified cable tester. Poor termination can reduce performance below the Category 6A target, even when the cable itself is of high quality.
Plan the installation before ordering. Confirm that the cable is Category 6A rated, that the plug and cable are compatible with the outlets and patch panels already on site, and that the termination tool suits the plug geometry. If the link must meet a specific standard or warranty requirement, check the Molex datasheet for the exact termination procedure and the approved cable types.
The Molex Field Terminated Plug CAT6A RJ45 gives network installers a flexible way to finish Category 6A cable runs to length. It suits structured cabling projects where custom lengths, repairs or site-specific layouts make pre-made patch leads impractical.
Molex
Field-terminated CAT6A RJ45 plug
Part code KSP-00001
Share this on your favourite channel: