





INFRASTRUCTURE TEAM
+27 (0) 11 237 1000
Molex
Field terminated RJ45 plug for Cat6 UTP cable
Terminated on site for structured network cabling
The Molex field-terminable RJ45 plug is a modular connector designed for Cat6 UTP copper structured cabling. It lets an installer terminate a plug directly onto a length of cable, rather than relying on a factory-made patch cord. This makes it a practical part for any site where cable lengths vary or where a lead needs to be made on the spot.
Field termination is one of the most flexible ways to finish a network connection. A factory patch cord comes in fixed lengths, which often leaves surplus cable coiled in a cabinet or ceiling void. With a field-terminated plug, the installer measures the run, cuts the cable to suit, and terminates the end. The result is a neater installation and less wasted cable.
This item is part of the Molex Datasheets range of structured-cabling components. Molex is a well-known supplier of copper and fibre connectivity, and this plug belongs to its field-terminable RJ45 family, specifically the MPTL group. It is intended for Cat6 UTP cable, which is unshielded twisted pair copper cable commonly used for Gigabit Ethernet and other standard data applications.
Successful termination depends on preparation. Strip the outer jacket carefully so that the twisted pairs are disturbed as little as possible. Keep the pairs twisted right up to the point where they enter the plug, because untwisting them can affect the performance of the link. Arrange the conductors in the correct wire order, trim them to the length specified in the Molex datasheet, and seat them fully before crimping.
Use the crimping tool recommended for this Molex plug. The correct tool applies even pressure and seats the contacts properly. An incorrect tool or a loose crimp can leave the connector unreliable, and the fault may only show up under load or after the link has been in service for a while.
Every field-terminated lead should be tested before it is put into use. A cable certifier or a basic continuity and wiremap tester will show whether all eight conductors are connected in the right order and that there are no shorts or open circuits. Testing at the time of installation is far cheaper than finding a fault after the building has been handed over.
This plug is aimed at network installers, cabling contractors and IT technicians who are comfortable with copper termination. It is not a consumer product, and it is best handled by people who have been trained in RJ45 termination and who know how to test the result.
For the exact dimensions, wire-order diagram, approved crimp tools and any performance figures, please refer to the official Molex datasheet for this part. Following the datasheet closely helps ensure that the finished lead meets the expected standard for Cat6 cabling.
Molex
Field terminated RJ45 plug for Cat6 UTP cable
Terminated on site for structured network cabling
Share this on your favourite channel: