





INFRASTRUCTURE TEAM
+27 (0) 11 237 1000
Molex
LC/LC DPX singlemode patch lead, OS1/2, 9/125µm, 2 m
For singlemode fibre patching between LC-terminated equipment
Molex LC/LC DPX OS1/2, 9/125 µm, 2 m is a ready-made fibre optic patch lead for linking network equipment to fibre patch panels and to other devices in a data room or cabinet. Both ends carry LC connectors, and the lead uses OS1/2 singlemode fibre with a 9/125 µm core and cladding. It is part of the Molex range of structured-cabling parts used for building and campus networks.
The product is a duplex LC-to-LC patch lead. The DPX label describes a duplex fibre construction, where two fibres are held together in one cable so that a transmit and a receive path can be run through a single lead. The OS1/2 code refers to the singlemode fibre category used for longer-reach and higher-capacity links, and 9/125 µm is the core and cladding diameter of singlemode fibre.
Singlemode fibre allows one light path through a very small core. This reduces modal dispersion, so signals can travel further and carry more data than on multimode fibre over the same distance. For that reason singlemode is commonly used for backbone runs between buildings, links between distribution frames, and connections to long-reach transceivers.
Using the correct fibre type matters. A singlemode lead should only be used with singlemode ports and transceivers. Mixing it with multimode equipment can cause poor performance or no link at all, so always confirm the port type on both the switch and the panel before connecting.
LC connectors are small form-factor plugs with a compact latch. They are widely used on modern switches, media converters, SFP and SFP+ transceivers and fibre panels because they take up less space than older connector styles. A pair of LC connectors on a duplex lead lets a single cable carry both directions of a link.
Keep fibre patch leads free of sharp bends, as tight bends can cause signal loss. Leave a little slack in the rack and route the lead through the cable management so that it does not carry the weight of other cables. Clean the LC connector ends before inserting them into a port, and use dust caps on any unused ports. Label both ends so the link can be traced later.
Choose this Molex LC/LC DPX OS1/2 lead when you need a short singlemode duplex patch between LC-equipped devices and a panel or switch. If your equipment uses a different connector such as SC or ST, or if the link is multimode, a different lead is needed. Before ordering, check the Molex datasheet for the jacket colour, fibre rating and any other detail that matters for your installation.
The Molex LC/LC DPX OS1/2 2M patch lead is a short, duplex singlemode fibre cable with LC connectors at both ends. It is suited to patching inside racks and cabinets, linking active equipment to fibre panels, and supporting singlemode structured-cabling networks.
Molex
LC/LC DPX singlemode patch lead, OS1/2, 9/125µm, 2 m
For singlemode fibre patching between LC-terminated equipment
Share this on your favourite channel: