





INFRASTRUCTURE TEAM
+27 (0) 11 237 1000
Molex
DataGate ModClip UTP Cat5e module, white
Copper Cat5e connectivity for structured cabling outlets

The Molex MODCLIP DATAGATE UTP CAT5E WHT is a white copper connectivity module from the Molex Cat5e range. It belongs to the ModClip DataGate family, a modular approach to data outlets that lets installers build clean, organised data points in offices, schools, clinics and other commercial spaces. The unshielded twisted pair (UTP) design and Cat5e rating make it a straightforward choice for general-purpose networking.
Structured cabling is built from a number of components that must work together: the horizontal cable, the outlet at the wall, the patch panel in the rack and the patch leads that join them. The DataGate modules are the part of this chain that sits at the outlet end. A well-chosen module keeps the connection stable, makes moves, adds and changes easier, and gives the installation a finished look that is easy to maintain over time.
This item is listed under the Molex Cat5e range and the CAT5e MOD-CLIP DATAGATE MODULES section of the price list. The supplier description identifies it as a ModClip DataGate UTP Cat5e module in white. Because it is part of a modular family, its exact fitting details depend on the housing or frame it is used with, so the installer should confirm compatibility with the other components on the job before ordering.
Modular outlets allow a single design to be adapted to many different wall boxes, surface boxes and furniture openings. Installers can start with a standard set of components and add more as the site grows. A white module blends into most interior finishes, which is helpful in offices and public buildings where the cabling should be visible but not distracting.
Cat5e is still widely specified for general office data, telephony and everyday network traffic. For many small and medium sites it provides the performance needed without the extra cost of higher categories. Where demand for bandwidth is expected to grow significantly, installers may choose Cat6 or Cat6A instead, and the supplier’s wider Molex range covers those options as well.
Good results depend on correct termination and testing. The cable should be terminated according to the manufacturer’s instructions, with the pair twists kept as close to the connector as the design allows. After installation, each link should be tested and the results recorded so that faults can be traced quickly later. Using Molex patch leads and other matching components from the same range helps keep the link within a consistent specification.
Keep the module away from sources of heavy electrical interference where possible, and route the cabling so that it is not crushed or pulled beyond its bend radius. These simple practices protect the performance of the link and the life of the installation.
Before ordering, check which housings, faceplates and frames the site uses, and confirm that the module is the right fit for them. Because the supplier information is brief, the installer should also check any detailed datasheet for the exact mounting, termination and performance figures that apply to this part. Ordering the matching outlet components and patch leads at the same time reduces the risk of mismatched parts on site.
In summary, the Molex MODCLIP DATAGATE UTP CAT5E WHT is a practical, white Cat5e copper module for structured data outlets. It suits offices, schools and commercial spaces that need a tidy, dependable connection point within a modular Molex system.
Molex
DataGate ModClip UTP Cat5e module, white
Copper Cat5e connectivity for structured cabling outlets
Share this on your favourite channel: