





INFRASTRUCTURE TEAM
+27 (0) 11 237 1000
Molex
Outdoor Cat6A shielded patch cord, 1m
Part of the Molex CAT 6A IP66 outdoor connectivity range
The Molex Outdoor Cat6A Shielded Patch Cord 1m is a short, ready-made copper patch lead built for network links that must withstand outdoor conditions. Supplied in a 1 metre length, it is intended for connecting equipment that sits close together, such as an outdoor outlet and a nearby switch, camera or wireless access point.
The cord belongs to the Molex CAT 6A IP66 outdoor connectivity range. The IP66 rating in the range name indicates a high level of protection against dust and water jets, which is why this range is aimed at installations exposed to rain, wind and dust. Within a structured cabling system, this patch cord completes the link between the fixed outdoor cabling and the active equipment inside or beside the enclosure.
Category 6A cabling is designed to support 10 Gigabit Ethernet over full channel lengths, and it offers more headroom than Category 6 or Category 5e. Although a 1 metre patch cord is only a small part of a channel, the patch cord still needs to meet the same performance class as the rest of the link. Using a Category 6A patch lead with Category 6A outlets and panels helps keep the overall installation consistent.
Outdoor and industrial areas often contain sources of interference, including power cables, motors, transformers and radio transmitters. A shielded patch cord helps reduce the effect of these sources on the data signal. Proper earthing of the shield at the equipment and panel end is important, so the installer should follow the earthing guidance supplied with the wider system.
An outdoor-rated range is designed for locations where the cable and connections may be exposed. In practice, this means the patch cord should be connected inside an enclosure or protected connection point wherever possible. Avoid leaving connectors unprotected, keep the cord clear of standing water and sharp edges, and check that all dust covers and seals are in place.
Before installing, confirm that the connector types at each end match the equipment ports and that the cord is compatible with the outlets in the same Molex range. Route the cord so it is not stretched or kinked, and allow a little slack so that enclosure doors and equipment trays can move freely. Label both ends so that the link can be traced easily during maintenance or fault finding.
This listing describes the product in general terms based on the supplier information available. For detailed electrical specifications, connector dimensions, cable diameter, operating temperature range and warranty terms, refer to the Molex datasheet for the specific part number, or contact the supplier before ordering.
Molex
Outdoor Cat6A shielded patch cord, 1m
Part of the Molex CAT 6A IP66 outdoor connectivity range
Share this on your favourite channel: