





INFRASTRUCTURE TEAM
+27 (0) 11 237 1000
Molex Cat6 UTP patch cord, LS0H sheath, 568A/B wiring, 10 metre length.
Article PCD-02019-0*, colour variants indicated by the -0* suffix.
The Molex PCD-02019-0* is a 10 metre Category 6 unshielded twisted pair (UTP) patch cord from the Molex structured cabling range. Patch cords like this one form the final link between active equipment and the permanent cabling in a network, so choosing the right length, category and jacket matters for a clean and reliable installation.
LS0H compounds emit little smoke and no halogen gases when burned. This makes them a sensible choice for indoor installations in buildings where occupants must be protected in the event of a fire, including offices, schools, hospitals and shared residential spaces. Where building codes or insurers call for low-smoke materials, an LS0H jacket helps meet that expectation.
The 568A/B wiring option refers to the pin-to-colour arrangement at each RJ45 plug. Both schemes are accepted in Ethernet installations, but the same scheme must be used at both ends of a cord. Keeping the whole site on one scheme makes testing and fault-finding far easier.
A 10 metre cord is longer than most rack-to-rack connections need, so it suits runs between a wall outlet and equipment at a distance, or cabinets where the patch panel is set back. Avoid bundling excess length tightly, as this can degrade performance and creates clutter. Route the cord away from power cables where possible to limit interference.
Before final connection, check that the wiring scheme on the plug matches the rest of the installation and test each link with a cable tester. Label both ends so future maintenance is straightforward.
Because the article number carries a colour suffix, confirm the colour required before placing an order. Colour coding is useful for distinguishing data, voice and uplink connections within a single cabinet.
Molex Cat6 UTP patch cord, LS0H sheath, 568A/B wiring, 10 metre length.
Article PCD-02019-0*, colour variants indicated by the -0* suffix.
Share this on your favourite channel: