





INFRASTRUCTURE TEAM
+27 (0) 11 237 1000
MOLEX
Cat6A patch cord with RJ45 connectors, 3 m, black
Part of the CAT 6A indoor IP67 connectivity range
The Molex PCORD C6A is a 3 metre black Cat6A patch cord with RJ45 connectors at each end. It belongs to the Molex CAT 6A indoor IP67 connectivity range, a family of copper components made for structured cabling networks. This patch cord is the short, ready-made lead that connects one part of a network to another, such as a wall outlet to a computer or a switch to a patch panel.
Structured cabling is the fixed infrastructure of an office, school, clinic or industrial site. It is normally made up of cable runs, outlets, patch panels and cabinets, joined together with patch cords at the points where users and equipment connect. Using matched components from one manufacturer helps the whole link work as a system, which is why the Molex range is often specified together.
The PCORD C6A is supplied as a finished assembly, so no field termination is needed. The black colour helps with identification in busy racks and wall boxes, and the 3 metre length suits the common distance between a cabinet and nearby equipment or between an outlet and a desk.
Cat6A is designed for higher bandwidth and better performance over longer runs than earlier copper categories. Installers choose it for new builds, for networks that carry heavy data traffic, and for sites where future upgrades are likely. Using a patch cord of the same category as the rest of the link helps avoid a weak point in the chain.
Plan the route before you connect. Keep patch cords as short as practical to reduce clutter, and leave a little slack for maintenance without making loops too large. Label each end so that the connection can be traced later. Avoid bending the cord sharply near the connector, and keep it clear of heat sources and sharp edges. Where cords are run through trunking or cable management, use the available routing to keep them tidy and easy to change.
A 3 metre cord is a common choice for linking equipment on the same desk or in the same rack section. If the distance is much longer or shorter, measure the actual route first and check the other lengths available in the range, rather than coiling excess cable, which can make a rack untidy and hard to manage.
The PCORD C6A suits network installers, electrical and data contractors, IT departments and facilities teams who maintain structured cabling. It is also useful for anyone who needs a dependable, ready-made Cat6A lead for a copper link in an office, school, hospital or industrial building.
For the full specification, including transmission performance, jacket details and the exact IP rating the Molex range is tested to, refer to the product datasheet supplied by Molex before installation.
MOLEX
Cat6A patch cord with RJ45 connectors, 3 m, black
Part of the CAT 6A indoor IP67 connectivity range
Share this on your favourite channel: