





INFRASTRUCTURE TEAM
+27 (0) 11 237 1000
Molex
Cat6A UTP patch lead, LS0H (low smoke zero halogen) sheath, blue, 7m
Part number PCD-09107-0H
The Molex PCORD C6A UTP LS0H Blue 7m is a Category 6A unshielded twisted pair patch lead, supplied in a 7-metre length with a blue low smoke zero halogen sheath. It is designed for the short copper connections that make up the active part of a structured cabling system, linking equipment in a cabinet or comms room to patch panels and wall outlets.
Structured cabling works best when every link in the chain is matched and predictable. Patch leads are the flexible part of that chain. They are handled far more often than the fixed installed cable, so a dependable patch lead protects the performance of the whole system. This Molex lead is intended for exactly that role, sitting between a switch or server port and a patch panel port, or between a wall outlet and a workstation.
The product name reads as follows: PCORD is the patch cord family, C6A refers to Category 6A performance, UTP means unshielded twisted pair, and LS0H is the low smoke zero halogen jacket. The 7M at the end is the length, 7 metres. The blue colour is the finish option used to differentiate leads in the same family. Checking these codes before ordering helps make sure the lead matches the rest of the installation, especially where the cabling category and jacket type must be consistent throughout a building.
Standard PVC jackets give off dense smoke and corrosive gases when they burn. LS0H compounds were developed to reduce that hazard. Where cabling runs through occupied areas, ceiling voids, plant rooms or enclosed cabinets, a low smoke zero halogen jacket is often the preferred choice. It supports a safer environment for building occupants and for the people who must respond in an emergency. Always follow the applicable building and cabling rules for the specific site.
A 7-metre lead gives enough slack for most cabinet and wall outlet distances without leaving a large loop of surplus cable. Measure the route before ordering, allowing for vertical runs and the slack needed to dress cables neatly. Avoid tight bends and keep patch leads away from sources of heavy electrical interference where possible. Good cable management reduces strain on the connectors and makes future changes far easier.
Molex copper products are designed to be used together. A Cat6A patch lead connects most cleanly to Cat6A patch panels and outlets from the same family. Mixing components from different categories can reduce the performance you expect from the link, so it is worth confirming compatibility with the installed hardware before you start. If your project uses a specific Molex datasheet or design guide, follow the specifications in that document.
Label both ends of every patch lead at the time of installation. Use the blue colour as a visual cue if your site standard assigns colours to particular functions. Keep leads properly supported on cable managers or trunking, and avoid stacking heavy bundles that press on the connectors. Test each link after installation to confirm it is working as intended.
In short, the Molex PCORD C6A UTP LS0H Blue 7m is a practical, well-matched Category 6A patch lead for structured copper networks that need a clean, low-smoke jacket and a neat, traceable finish.
Molex
Cat6A UTP patch lead, LS0H (low smoke zero halogen) sheath, blue, 7m
Part number PCD-09107-0H
Share this on your favourite channel: