





INFRASTRUCTURE TEAM
+27 (0) 11 237 1000
Molex
PowerCat 5e DataGate jack, UTP, wired to 568A/B
White finish, for Cat5e structured cabling
The Molex PowerCat 5e DataGate jack is a white unshielded twisted pair (UTP) outlet for Category 5e structured cabling. It forms the fixed end of a permanent network link, terminating the copper cable in the work area so that devices can be connected quickly and neatly. Within the Molex Cat5e range it sits alongside patch panels, patch leads, faceplates and surface boxes, and it is one of the DataGate outlet options used to build a complete copper data point.
The TIA/EIA 568A and 568B pinouts define how the eight conductors of a twisted pair cable are arranged inside an RJ45 outlet. Either scheme works, provided the same one is used consistently at both ends of every link. The description lists 568A/B, which tells installers the jack is compatible with both approaches, so they can match the scheme already used on the site. Mixing schemes within the same link can cause faults, so it is good practice to label the cable and record the chosen pinout on the as-built documentation.
DataGate outlets are designed to be fitted into a modular faceplate or wall box, which makes them easy to install during a new build and to change later. A typical installation runs Cat5e cable from the patch panel in the comms cabinet to the wall or floor box, terminates the cable on the back of the jack, and snaps the jack into the faceplate. Because the outlet is modular, a single faceplate can often carry several outlets, and an outlet can be replaced without disturbing the rest of the wall plate.
For a consistent link, pair the jack with Cat5e cable and the matching Molex Cat5e patch panel at the rack end. Using the same product family for the faceplate, the outlet and the patch leads helps keep the installation uniform and simplifies testing. Plan the number of outlets per room and leave spare capacity for future growth, since adding a jack later is simpler when the cable run and faceplate position were planned in advance.
Keep the cable untwisted only as far as needed at termination, and follow the bend radius and pair-handling guidance in the supplier documentation. Terminate each conductor carefully against the colour code of the chosen scheme, seat the jack firmly, and test each link after installation. Label both ends of the cable so that the outlet can be traced back to its patch panel port.
This jack suits installers, network contractors, facilities teams and IT managers who need a dependable Cat5e outlet for general office and building networking. It is a practical choice where the Molex DataGate system is already specified, or where a white outlet is wanted to match an existing faceplate. For higher bandwidth requirements, a Cat6 or Cat6A DataGate or equivalent outlet may be more suitable, and that should be checked against the project specification.
Molex
PowerCat 5e DataGate jack, UTP, wired to 568A/B
White finish, for Cat5e structured cabling
Share this on your favourite channel: