





INFRASTRUCTURE TEAM
+27 (0) 11 237 1000
The Molex SC/SC DPX OM3 fibre patch lead is a 1 metre multimode fibre jumper designed for short-reach connections in structured cabling. It has an SC connector on each end and uses 50/125µm OM3 multimode fibre. It is a practical choice for linking active network equipment to a patch panel, or for connecting two panels inside the same cabinet.
Structured cabling relies on well-organised patching. A short, correctly sized patch lead keeps the cabinet tidy, makes fault finding easier and reduces the risk of strain on the connectors. The 1 metre length is intended for close connections where the equipment and panel sit next to each other in the same rack.
OM3 is a multimode fibre grade. Its 50/125µm core is designed for use with short-wavelength light sources, which makes it suitable for the shorter runs typically found in buildings and data centres. For the exact performance figures, refer to the Molex datasheet for this part.
SC connectors use a push-pull latching action. They click in when fully seated and release with a simple pull on the body of the connector. This makes them quick to install and easy to disconnect, which is helpful when a rack is reconfigured or a link is moved.
Handle fibre patch leads carefully. Avoid tight bends, do not pull on the cable itself, and keep the connector end caps in place until the lead is installed. Route the lead through the cable management in the cabinet so that it does not hang loose or press against other equipment. Always check that the connectors are clean before connecting them, because dust on the ferrule is a common cause of poor link performance.
Before ordering, confirm the connector types on both the equipment and the panel, and check that the fibre grade matches the rest of the link. Using a Molex lead alongside Molex panels helps maintain a consistent system. Keep a few spare patch leads of the same type so that a faulty link can be replaced without delay.
The Molex SC/SC DPX OM3 fibre patch lead is a straightforward, purpose-built jumper for short multimode connections. It suits anyone building or maintaining a structured cabling system who needs a neat, reliable 1 metre link between active equipment and fibre panels.