





INFRASTRUCTURE TEAM
+27 (0) 11 237 1000
The Siemon ZMAX Cat6A Shielded 48-Port Copper Patch Panel is built to bring order to copper data cabling. Mounted in a standard 19-inch rack or cabinet, it provides 48 jacks in a single rack unit, creating a tidy termination point between horizontal cabling and the active equipment that serves your network. It is part of the ZMAX/MAX range, which Siemon designs as a connected set of copper outlets, panels and management accessories.
Structured cabling is only as good as its organisation. A patch panel like this one gives every cable run a fixed, labelled home, so moves, additions and changes can be made without tracing wires through a cabinet. The flat design keeps the front profile slim, and the black finish blends in with most network racks.
Dense patching can quickly become difficult to manage. The fixed wire manager on this panel helps hold incoming cables in an orderly arrangement, which keeps the rear of the cabinet easier to work in. Good cable management also reduces strain on terminations and makes it simpler to trace faults when they occur. When planning a rack, leave room for patch leads to run cleanly between the panel and the equipment ports.
Category 6A cabling is chosen for demanding copper networks where higher bandwidth and well-controlled cable runs matter. Shielding is part of the design intent of this panel, supporting installations that need organised, protected copper connections. Always confirm that the cabling, outlets and patch leads used in your installation are of the same category and match the rest of the system, so that the complete link performs as intended.
In each of these settings, the panel acts as the handover point between permanent cabling and the moveable patch leads that connect users and devices. Technicians can add, change or remove connections at the front while the building cabling stays in place at the rear.
Mount the panel in a rack space that leaves enough depth for the wire manager and the bend radius of incoming cables. Label each port clearly, and keep a record of which outlet is connected to which socket. Use a consistent colour scheme for patch leads so that new connections are easy to recognise. Check that the rack and cabinet you are using are suitable for 19-inch equipment before fitting.
This product is offered from Siemon clearance stock. Stock is limited to what is currently on hand, so it is worth checking availability before planning a project around it. For a complete system, pair the panel with matching Category 6A outlets, patch leads and cable management from the same range where possible.