





INFRASTRUCTURE TEAM
+27 (0) 11 237 1000
The Tripp Lite N845B-10M-12-MG is a 10 metre multimode fiber optic cable designed for high-speed data links in data centres, server rooms and network backbones. It uses 12 fibres with MTP/MPO connectors on both ends, allowing a single cable to carry multiple parallel optical channels for 100G applications.
Multimode fiber carries light over short distances through a relatively wide core. This product uses 50/125 micron OM4 multimode fiber, the grade typically specified for 100G parallel optics over shorter runs. It is a patch-type assembly, meaning it is intended to connect equipment or panels that are already installed.
MTP/MPO is a multi-fibre connector that combines several fibres into one compact ferrule. Twelve fibres is a standard count for parallel 100G transmission, where each pair of fibres handles one direction of a channel. Using a single MTP/MPO cable simplifies cable management compared with running many individual duplex patch leads.
LSZH jackets release very little smoke and no halogen gases when exposed to heat or fire, which is often required in enclosed spaces such as data centres, offices and public buildings. Magenta is the common colour code for OM4 multimode fiber, helping technicians identify the correct cable type at a glance.
This cable is suited to connecting switches, servers or storage devices to patch panels or cassettes that use MTP/MPO ports. It can also be used in a leaf-and-spine or backbone design where short multimode runs link equipment in adjacent racks. The 10 metre length gives enough slack for typical intra-row or inter-rack connections.
Handle MTP/MPO connectors carefully and keep the end faces clean and covered until they are connected. Route the cable without sharp bends and avoid pulling on the jacket. Confirm that the polarity method used in your link matches the cable configuration before installation, since MTP/MPO links depend on correct fibre alignment.
The product listing does not give insertion loss, bend radius, tensile rating or detailed performance figures. For those values, consult the manufacturer’s documentation. Make sure the connector type and fibre count match your switch or transceiver requirements.



