





INFRASTRUCTURE TEAM
+27 (0) 11 237 1000
Tripp Lite
Cat6a straight-through modular in-line snap-in coupler, RJ45 female to female
TAA compliant, lifetime limited warranty
The Tripp Lite Cat6a Straight-Through Modular In-Line Snap-In Coupler (RJ45 F/F) is a copper network coupler for joining two RJ45 cables in a straight line. Both ends are female RJ45 ports, so you can connect two male-terminated patch leads or cable ends without re-terminating either one. It is intended for Cat6a copper network installations and is supplied by Tripp Lite, part of the Eaton connectivity range.
In a structured network, cable length and routing do not always match the layout of a room or cabinet. A coupler solves that problem quickly. Instead of replacing a long patch lead or pulling new cable, you join the existing run at a convenient point. The coupler keeps the link straight-through, meaning pin positions carry across unchanged from one side to the other, which is what a standard Ethernet connection requires.
The coupler is most often used where two copper runs meet. In a data cabinet, it can extend a patch lead that is just slightly too short to reach a switch or patch panel. On a wall, it can join a horizontal cable to a short lead that feeds a desk, a wireless access point or a telephone device. In offices, schools, clinics and commercial premises, it provides a tidy way to bridge a gap without visible slack or a new cable run.
It is also useful during maintenance and moves. When equipment is relocated, a coupler can bridge the new position to the existing cabling while a permanent solution is planned. Because it is an in-line part, it adds a joint to the link, so it should be placed where it is accessible and protected from strain. Keep the total channel length within the limits of your cabling standard, and avoid stacking several couplers in one link.
Check that both cable ends are terminated to the same pinout before joining them with the coupler. Route the coupler so it is not under tension, and secure it in a panel, box or cabinet rather than leaving it loose on the floor. Where the link carries important traffic, label both ends so future technicians can trace it. Test the completed link with a cable tester to confirm continuity and wiring before handing it over.
For buyers who need a dependable, standards-based way to join Cat6a copper cables, this coupler offers a simple solution with a lifetime limited warranty and TAA compliance. It is a sensible addition to a stock of network components for installers, IT departments and facilities teams.
Tripp Lite
Cat6a straight-through modular in-line snap-in coupler, RJ45 female to female
TAA compliant, lifetime limited warranty
Share this on your favourite channel: