





INFRASTRUCTURE TEAM
+27 (0) 11 237 1000
Tripp Lite
Cat6a 10G snagless UTP Ethernet patch cable, RJ45 to RJ45
Black, 25 ft (7.62 m)
The Tripp Lite N261-025-BK is a black Cat6a Ethernet patch cable for structured network connections. It is built for 10 Gigabit Ethernet and gives a dependable copper link between active network equipment and wall or rack outlets. The 25 ft (7.62 m) length makes it a practical choice for most office and data room layouts.
Cat6a is the category of twisted pair cabling designed for 10G operation over longer runs than standard Cat6. Choosing a Cat6a patch cable helps keep the whole link, from the outlet to the switch port, at the same performance level, which matters when faster network speeds are planned or already in use.
The cable is commonly used to connect a PC, laptop docking station, IP phone, printer or wireless access point to a wall outlet or patch panel. In a comms rack it links a patch panel to a switch, router or server. It can also be used in cabinet-to-cabinet links where the distance fits the length.
Plan the route before cutting or routing the cable. Leave a small service loop rather than pulling the cable tight, and keep it away from mains power cables where possible to reduce interference. Label both ends so that the link is easy to trace later. Avoid sharp bends, which can damage the cable jacket and the twisted pairs inside.
Measure the actual route, including vertical runs down to a rack or up to a ceiling tray, and add some allowance for connection and slack. The 25 ft length suits runs of moderate distance. If the path is much shorter, a shorter patch cable will keep cable clutter lower and make the installation neater.
A snagless moulded boot helps prevent the latch from breaking when cables are plugged and unplugged in busy cabinets. Consistent construction across each patch cable also makes it easier to maintain a uniform network installation. The supplier lists a lifetime limited warranty for this item; check the warranty terms supplied with your order for conditions.
Use the N261-025-BK for everyday network connections where Cat6a performance is wanted. It is a straightforward, neat solution for both new installations and upgrades to existing copper networks.
Tripp Lite
Cat6a 10G snagless UTP Ethernet patch cable, RJ45 to RJ45
Black, 25 ft (7.62 m)
Share this on your favourite channel:



