





INFRASTRUCTURE TEAM
+27 (0) 11 237 1000
Tripp Lite
QSFP+ 40GBase-SR4 transceiver, MTP/MPO multimode fiber
40 Gbps, 850 nm, up to 400 m (1312 ft.), Cisco-compatible
The Tripp Lite N286-40G-ESR4-C is a QSFP+ optical transceiver for high-speed short-reach networking. It delivers 40 Gigabit Ethernet over multimode fiber using the 40GBase-SR4 standard, and it is described as Cisco-compatible. It is intended for network administrators and installers who need to upgrade or extend a switch-to-switch or switch-to-server link without moving to longer-reach optics.
Tripp Lite is part of the Eaton group, and this module sits in the company’s fibre connectivity range alongside its cables and adapters.
This transceiver is most often used in data centres and server rooms for top-of-rack links, spine-to-leaf connections and backbone runs between cabinets. It can also serve campus or building networks where existing multimode fiber with MTP/MPO terminations is in place.
The MTP/MPO interface requires a matching multimode fiber cable or trunk. Confirm that your switch or router has an available QSFP+ port and supports 40GBase-SR4 optics. Because the module is Cisco-compatible rather than an original Cisco part, check that your equipment accepts third-party transceivers.
Keep the MTP/MPO connector clean and covered until it is connected. Dust on the end face is a common cause of link errors in multimode networks. Use the correct polarity method for your MPO trunk so that transmit and receive lanes line up correctly.
It offers a cost-effective way to run 40 Gbps over existing multimode fiber without installing single-mode cabling. The 400 m reach covers most in-building and inter-building short runs. The 3-year limited warranty adds peace of mind for a permanent installation.
Tripp Lite
QSFP+ 40GBase-SR4 transceiver, MTP/MPO multimode fiber
40 Gbps, 850 nm, up to 400 m (1312 ft.), Cisco-compatible
Share this on your favourite channel: