





INFRASTRUCTURE TEAM
+27 (0) 11 237 1000
Tripp Lite
40GBase-SR4 QSFP+ transceiver, multimode MTP/MPO, 850 nm, up to 150 m
Cisco-compatible QSFP-40G-SR4 style
The Tripp Lite N286-40GSR4-MTP is a QSFP+ optical transceiver for 40 Gigabit Ethernet over multimode fibre. It is described as a Cisco-compatible QSFP-40G-SR4 module, which means it is designed to match the form factor and short-reach optical standard that the QSFP-40G-SR4 uses. The module is part of the Tripp Lite connectivity range from Eaton and is listed in the shop under Transceiver Modules, Multimode Fiber.
Short-reach 40G links are common in data centres and busy server rooms, where switches and servers are placed close together but still need more capacity than 10G can provide. A 40GBase-SR4 transceiver answers that need by sending parallel optical signals over multimode fibre, using separate fibre pairs inside one MTP/MPO connector. This is why the N286-40GSR4-MTP is built around an MTP/MPO interface rather than a standard duplex connector.
A QSFP+ transceiver plugs into a compatible port on a switch, router, server network card or other host device. Once the module is installed, the port can be configured for 40G operation according to the host equipment’s documentation. The transceiver converts electrical signals to light and back again, so the fibre cabling between two ends must match the optical standard. For 40GBase-SR4, that means a multimode MTP/MPO trunk or patch cable at the link.
Because the MTP/MPO connector carries several fibres in one plug, cabling is neater than running many separate duplex patch leads. It also means that the polarity and fibre mapping of the trunk cable must be correct at both ends. Installers commonly use a cassette or panel that is designed for MTP/MPO connectors to keep these links organised and easy to trace.
The module is rated for up to 150 m on multimode fibre at 850 nm. Actual reach depends on the fibre grade installed, the quality of the connections and the total loss in the link, so the cabling plan should be checked against the fibre specification before installation. Keeping connectors clean is one of the simplest ways to protect link performance, especially with MTP/MPO connectors that carry multiple fibres.
Confirm that your switch or network device has QSFP+ ports and supports 40GBase-SR4 optics. Check the fibre type and length between the two ends, and make sure you have the matching MTP/MPO cabling. If you are unsure whether this module suits a particular switch or cable plant, ask for advice before buying, as mismatched optics and cabling are a common cause of links that will not come up.
Tripp Lite
40GBase-SR4 QSFP+ transceiver, multimode MTP/MPO, 850 nm, up to 150 m
Cisco-compatible QSFP-40G-SR4 style
Share this on your favourite channel: