





INFRASTRUCTURE TEAM
+27 (0) 11 237 1000
Tripp Lite
Duplex Singlemode 9/125 Fiber Patch Cable, LC to ST, 3M (10 ft.)
Lifetime limited warranty
The Tripp Lite N368-03M is a duplex singlemode fiber patch cable designed to join network equipment that uses different connector types. One end has an LC connector and the other end has an ST connector. The cable measures 3 metres, which is 10 feet. It is a short patch lead intended for connections inside a rack, between panels and equipment, or between two devices in the same room or building area.
Fibre patch cables are a simple but important part of any network. They carry data as pulses of light instead of electrical signals, so they are not affected by electrical interference and can carry large amounts of data over distance. Choosing the correct fibre type and connector is essential, because a mismatch can stop a link from working even when the cable itself is in good condition.
The numbers 9/125 refer to the glass structure of the fibre. The core, which carries the light, is 9 micrometres in diameter. The cladding, which surrounds the core and keeps the light inside it, is 125 micrometres across. Singlemode fibre allows only one light path through the core. Because of this, signals spread out less over distance than they do in multimode fibre. Singlemode is therefore the usual choice for longer links, backbone connections between buildings, and applications where the highest signal quality is needed.
LC connectors are compact, with a small ferrule and a latching push-pull action. They are the common choice for modern switches, transceivers and fibre panels because they take up little space, which matters in crowded racks. ST connectors use a twist-to-lock bayonet design and a larger ferrule. They are older but still present in many buildings, especially on legacy panels, security installations and older network equipment. A patch cable with LC at one end and ST at the other lets these two worlds connect without replacing working hardware.
Keep fibre patch cables away from sharp bends, because bending too tightly can damage the fibre and weaken the signal. Keep connector end faces clean and covered until they are plugged in. Dust and fingerprints on a connector are a common cause of poor performance. Label both ends so that the link is easy to trace later. Always check that the connector types match the ports at each end before connecting the cable.
The N368-03M is a practical, ready-made patch lead for a common problem: joining LC and ST equipment. Its duplex design gives a full two-way link in one cable, and its singlemode fibre suits runs where signal quality and reach are important. Because it is a short 3-metre lead, it is well suited to patching jobs inside a single room or cabinet.
Tripp Lite
Duplex Singlemode 9/125 Fiber Patch Cable, LC to ST, 3M (10 ft.)
Lifetime limited warranty
Share this on your favourite channel:



