





INFRASTRUCTURE TEAM
+27 (0) 11 237 1000
The Tripp Lite N390-02M-8LC-AP is a two-metre singlemode breakout patch cable that bridges high-density MTP/MPO fibre connections and standard LC fibre connections. It is built for 40 and 100 Gigabit Ethernet networks, where a single MTP/MPO port carries several fibre pairs that must be distributed to individual LC ports.
In practical terms, the cable has one MTP/MPO connector on one end and four LC connectors on the other. Each LC connector terminates one fibre pair, so one high-density port can feed four separate links. This breakout arrangement is common in leaf and spine switch deployments and in cabling systems that move from MTP/MPO trunks to LC patch panels.
The MTP/MPO end uses an angled physical contact polish, while the LC ends use an ultra physical contact polish. These finishes are designed to mate with specific port types. Connecting an APC connector to a UPC port, or the reverse, can cause poor optical performance and may damage connectors. Before ordering, confirm that the transceiver or patch panel ports on both sides match the polish of this cable.
Plenum cable has a jacket designed to be installed in air-handling spaces, such as above suspended ceilings or under raised floors used for air circulation. Using plenum-rated cable in these areas is generally required under fire and building regulations. Plenum rating is about where the cable may be routed; it does not change the fibre performance.
Singlemode fibre has a very small core, which allows light to travel long distances with low dispersion. It is used for longer runs than multimode fibre and for links that need higher bandwidth over distance. The yellow jacket is a common colour code for singlemode cable, helping installers identify it quickly in a mixed cabling environment.
Keep the cable away from sharp bends and avoid pulling on the connectors. Use dust caps on any unused connectors until the cable is installed. Label each LC leg with its channel number so that the four links can be traced easily. Check the cable routing before final mounting so the length of two metres is enough for the intended path without excessive slack.
This cable suits network engineers, data centre technicians, cabling installers and IT managers who are upgrading to 40 or 100 Gigabit Ethernet and need a neat breakout between high-density fibre ports and LC patch panels. It is a specialised component, so check the compatibility of the optics and port types before purchase.



