





INFRASTRUCTURE TEAM
+27 (0) 11 237 1000
The Tripp Lite N816-10M is a ready-made duplex multimode fibre optic patch cable, 10 metres (33 ft) long, for linking network switches, servers, patch panels and other active equipment. It is built with 50/125 micron OM3 multimode fibre and an LC connector at one end and an SC connector at the other, so it can join equipment with different fibre port types without an adapter.
Fibre patch cables are the short jumpers that carry data between devices in a data cabinet or comms room. Unlike copper leads, they carry light instead of electrical signals, which keeps them free from electrical interference and lets them cover longer distances at high speed. The N816-10M is labelled as 10Gb, which describes the data rate it is designed to support over OM3 fibre.
Duplex means the cable contains two fibres, one for each direction of traffic, so each end is a pair of connectors in one cable. OM3 is a grade of multimode fibre designed for 10 Gigabit links over moderate distances. The 50/125 figure gives the diameter of the fibre core and cladding in microns. LSZH stands for low smoke zero halogen, a jacket material that produces limited smoke and no halogen gases when exposed to fire. LC is a small form-factor connector with a latch, and SC is a larger push-pull connector commonly found on older and some industrial equipment.
This cable suits indoor connections where both devices have matching fibre ports and the run is short. Common examples include linking a top-of-rack switch to a patch panel, connecting a server or storage device to a network switch, joining two switches in adjacent cabinets, and making a backbone connection between floors or rooms in a building. Because the length is 10 metres, it works well for connections across a single rack row or between cabinets placed close together.
Keep fibre patch cables away from sharp bends, because tight bends can increase signal loss. Keep the connector end-faces clean and fit the dust caps until the cable is connected. Route the cable through cable managers so that it is not pulled or stepped on. Label both ends so that the link is easy to trace later. Check that the connector types on the device side match LC and SC before ordering, and confirm the fibre grade required by the equipment’s specification.
The N816-10M offers a simple, ready-to-use link without the need for field termination tools or fusion splicing. The LSZH jacket is a practical choice for installations where fire safety is a concern, and the aqua colour helps identify multimode runs in a mixed cabling environment. The lifetime limited warranty from Tripp Lite gives added assurance on a product intended for permanent building infrastructure.
Fibre patch cables are a small part of a network, but a poor-quality or mismatched cable can limit the performance of an otherwise good system. Choosing a cable with the correct fibre grade, connector types and length for the job is an easy way to avoid problems later.