





INFRASTRUCTURE TEAM
+27 (0) 11 237 1000
The Tripp Lite N820-15M-OM4 is a 15-metre duplex multimode fiber optic cable for high-speed network connections. It is built with 50/125 micron OM4 multimode fiber and LC connectors on both ends, and it is designed for 100G links. It suits the kind of cabling used between network switches, servers, storage systems and patch panels in modern data rooms and office networks.
Multimode fiber carries light through a relatively wide core, which allows several light paths at once. This makes it a practical choice for short and medium runs inside a building, where the cost and handling of single-mode cable are not needed. OM4 is a higher grade of multimode fiber than older OM1 or OM2, and it is commonly chosen where higher data rates are required over the same kind of distance.
LSZH stands for low smoke, zero halogen. When this type of jacket burns, it releases less smoke and no halogen gases, which is helpful for people and equipment in enclosed spaces such as server rooms, offices, schools and public buildings. Many building and installation rules ask for LSZH cable in these areas, so the jacket type is often a deciding factor when choosing patch cables.
LC connectors are small, push-pull connectors that are widely used on modern transceivers and patch panels. A duplex LC cable has two fibres joined together, one for transmitting and one for receiving. Keeping both fibres in one assembly simplifies installation and reduces the chance of mixing up the send and receive paths.
Fibre patch cables should be handled with care. Avoid sharp bends, do not pull on the cable by the connector, and keep the connector end faces clean and covered until they are plugged in. Route the cable so that it is supported along its length, and leave enough slack for future changes without forcing a tight bend.
The N820-15M-OM4 is listed in the Tripp Lite range supplied through the Eaton connectivity products. The item carries a lifetime limited warranty as shown for this product. Check that the connector type and fibre grade match the transceivers and patch panels in your network before installing.



