





INFRASTRUCTURE TEAM
+27 (0) 11 237 1000
The Tripp Lite N820-25M is a 25 metre (82 ft) duplex multimode fibre optic patch cable designed for 10 Gb network connections. It uses 50/125 micron OM3 multimode fibre with LC connectors on both ends, and it has an LSZH jacket in aqua. It is a straightforward patch lead for linking active network equipment to passive cabling, or for connecting devices within a server room, comms cabinet or office network closet.
Fibre optic cabling carries data as pulses of light through a glass core rather than electrical signals through copper. This gives higher bandwidth over longer distances and makes it immune to electromagnetic interference. Patch cables like the N820-25M are the short jumpers that connect equipment ports to a patch panel or to each other, so they are used in almost every fibre network.
OM3 is a generation of multimode fibre optimised for laser-based transmission at 10 Gb speeds. The 50/125 micron size refers to the diameter of the glass core and cladding, and it is the standard for multimode links. LC is a small form-factor connector with a 1.25 mm ferrule, which takes up less space than older connector types and is found on most modern transceivers and patch panels. Duplex means the cable contains two fibres, one for sending and one for receiving, so a single lead provides a full two-way link.
LSZH stands for low smoke, zero halogen. When this jacket burns it produces little smoke and no halogen gases, which is important in enclosed spaces where people and equipment must be protected. Many building and installation standards call for this type of sheath in occupied areas.
The N820-25M suits a range of network jobs. In a comms room it can link a switch to a patch panel, or a patch panel to a core router. In a data centre it can connect a server or storage device to a top-of-rack switch. In offices and campuses it can join floor distribution equipment to the main network. The 25 metre length gives room for connections between racks in different parts of a room or between cabinets on opposite sides of a floor.
Before connecting, check that both ends match the equipment: LC on the device side and LC on the panel side. Keep the bend radius generous, avoid pinching the cable in cable ties, and route it away from sharp edges. Label each end so that links can be traced later. Clean the connector ends with proper fibre cleaning tools before inserting them into transceivers or adaptors, since dust is the most common cause of poor fibre performance.
This cable is suitable for network installers, IT technicians, system integrators and businesses that are building or upgrading a fibre network. It is also a useful spare to keep in stock for quick replacements. Because the product is listed with a lifetime limited warranty, buyers can plan longer-term deployments with confidence, subject to the terms of that warranty.