





INFRASTRUCTURE TEAM
+27 (0) 11 237 1000
Tripp Lite
PDU power cord, C13 to C14, 10A 250V, 2M, black
Lifetime limited warranty
The Tripp Lite PDU Power Cord C13 to C14 is a two-metre power cable for connecting rack-mounted equipment to a power distribution unit (PDU) or uninterruptible power supply. It is a standard IEC cord with a C13 connector at one end and a C14 connector at the other, rated at 10A and 250V.
Power distribution units are used in server rooms, data centres, network cabinets and comms rooms to supply several devices from one circuit. Each device needs a short, reliable cord between its inlet and a PDU outlet. This cord is sized for that job and is finished in black to match most rack equipment.
This cord is used to power servers, network switches, routers, storage arrays and other IT equipment mounted in a cabinet. It is also suitable for connecting office or lab equipment that uses a standard C14 inlet to a nearby PDU or wall-mounted power strip.
A two-metre cord gives enough reach from a PDU mounted at the back or side of a cabinet to equipment at the front or middle of the rack, without leaving a large loop of spare cable. Shorter or longer lengths may be needed for other layouts, so check the rack layout before ordering.
Match the connector ends to the equipment and PDU before fitting. Keep the cord away from sharp edges and do not run it under heavy loads. Route it cleanly with cable management so airflow and access to equipment are not blocked.
Always check that the total load on a PDU circuit stays within its rating. The 10A rating of this cord should be considered when adding up the power drawn by connected equipment.
Tripp Lite
PDU power cord, C13 to C14, 10A 250V, 2M, black
Lifetime limited warranty
Share this on your favourite channel: