





INFRASTRUCTURE TEAM
+27 (0) 11 237 1000
The Tripp Lite PoE to USB Micro-B and RJ45 Active Splitter is designed for situations where a device needs both a network connection and a 5V power supply, but only one cable can practically reach it. It separates the incoming Power over Ethernet signal into two outputs: a USB Micro-B port delivering regulated 5V at 1A, and an RJ45 port that continues the network connection. The result is a simple way to bring power and data to a remote device over standard network cabling.
Power is supplied according to the 802.3af standard, with the splitter stepping the 48V PoE input down to 5V. Because the splitter is active, the conversion takes place inside the unit, which allows the output to be delivered through a common USB Micro-B connector.
Many small devices such as network sensors, IP accessories, compact controllers and some cameras are fitted with a USB Micro-B power input but are installed where no mains socket is nearby. Running a single Ethernet cable and splitting it at the device removes the need for a separate power adapter and the outlet that would go with it. This can lower installation cost and make the installation cleaner, since only one cable leaves the network switch.
Installers and IT staff commonly use this type of splitter for:
Before connecting the splitter, confirm that the PoE source provides 802.3af power and that the total load of the connected device stays within the 1A output limit. The maximum cable length of 100 metres applies to the run between the PoE source and the splitter, and the cabling should be suitable for the network installation as a whole.
Because the product is an active unit, it is not a passive adapter. Check that the device connected to the USB Micro-B port expects a 5V supply, as connecting a device that needs a different voltage may damage it.
The Tripp Lite PoE to USB Micro-B and RJ45 Active Splitter is covered by a 3-year limited warranty. Keep the purchase record with the product, and refer to the warranty terms supplied with the unit for conditions and coverage details.
In summary, this splitter suits anyone who needs to deliver both network connectivity and 5V USB power over a single Ethernet run of up to 100 metres, with a simple installation and no separate power adapter.