





INFRASTRUCTURE TEAM
+27 (0) 11 237 1000
Tripp Lite
Rigid industrial IP68 duplex multimode fiber coupler, LC to LC, with dust cap
Supports 10G Ethernet
The Tripp Lite Rigid Industrial IP68 Duplex Multimode Fiber Coupler is a robust connector for joining two multimode fiber links that use duplex LC connectors. Designed for demanding environments, it combines an IP68 rating with a rigid housing and a dust cap, making it suitable for industrial 10G Ethernet networks where standard couplers would be exposed to dust, moisture and mechanical stress.
In a fiber network, a coupler is a passive component that aligns two connector ends so that light can pass from one cable to the next. This coupler is a duplex device, which means it handles both fibers of an LC duplex pair in a single unit. Installers can therefore join a complete transmit and receive link with one connection point rather than two separate ones.
Couplers are useful when a cable run is longer than one reel, when a permanent link needs a service point, or when a patch lead must be connected to an installed cable through a fixed panel or enclosure. Using a coupler in the right place keeps the system easy to maintain and reduces handling of the installed fiber itself.
The IP68 rating indicates that the housing resists the ingress of dust and can withstand continuous immersion in water under the conditions stated by the manufacturer. For cable connections that sit in outdoor boxes, wet plant areas, mining sites, food processing lines or unheated sheds, this protection helps keep the optical interface clean and dry. Contamination of the fiber end face is a common cause of link loss, so a sealed coupler is valuable where cleaning access is limited.
Before connecting, inspect both LC ports and the ferrules at each end of the fiber. Keep the dust cap on any port that is not in use. Clean connectors with an approved fiber cleaning tool and avoid touching the ferrule surfaces. Align the connectors carefully and push them fully into the coupler until they seat. Check that the duplex connectors match the polarity required by the link design before the system is powered up.
This coupler is aimed at network installers, industrial automation engineers and facilities teams who maintain fiber links in demanding conditions. It is also a sensible choice for system integrators who need a dependable interface that will not need frequent replacement. Because it is designed for 10G Ethernet over multimode fiber, it fits networks that use duplex LC connectivity at that speed. Confirm that the fiber type and connector configuration of the existing link match this unit before installing it.
The Tripp Lite Rigid Industrial IP68 Duplex Multimode Fiber Coupler with dust cap gives a rugged, sealed, duplex LC connection point for multimode 10G Ethernet links. It is well suited to industrial and outdoor fiber networks where dust and moisture protection and stable alignment matter.
Tripp Lite
Rigid industrial IP68 duplex multimode fiber coupler, LC to LC, with dust cap
Supports 10G Ethernet
Share this on your favourite channel: