





INFRASTRUCTURE TEAM
+27 (0) 11 237 1000
The Tripp Lite U209-006-RJ45-X is a USB-A to RJ45 serial rollover cable built for direct console access to networking hardware. It combines a USB-A male connector for the computer side with an RJ45 male connector for the console port on the device, so a technician can open a terminal session without relying on the network.
Console access is the first step when a switch, router or firewall is new, when its network settings have been lost, or when it cannot be reached over the network. This cable is described as Cisco compatible, so it suits the many Cisco-style console ports found on network equipment.
A rollover cable crosses the wire pairs so that pin 1 at one end connects to pin 8 at the other. This is the wiring pattern used by the console interface on Cisco equipment, so the cable is the correct tool for that job. Using a standard network patch lead in its place will not give a working console session.
The 6 ft length suits most desk and rack setups where the laptop sits close to the equipment. The USB-A connector works with the standard USB ports found on most modern laptops and desktops, so no separate serial port is needed on the computer. A terminal emulator on the computer is still required to communicate with the device once the cable is connected.
Keep the cable free of sharp bends and avoid pulling on the connectors. Store it coiled loosely in the equipment kit so the RJ45 end and the USB end stay in good condition.
Before buying, confirm that the console port on your device uses an RJ45 connector and that the device is Cisco compatible for this purpose. The product is a standard Tripp Lite part number, and the listing gives the data rate and length shown above.



