





INFRASTRUCTURE TEAM
+27 (0) 11 237 1000
The Tripp Lite U328-025 is a 25 foot (7.62 metre) USB 3.0 SuperSpeed active repeater cable for connecting USB 3.0 devices over a longer distance than a standard USB cable allows. It is part of Tripp Lite’s USB cable range, which is supplied by Eaton, and it is offered in the USB-A category.
Standard passive USB cables lose signal quality as the run gets longer. This cable solves that problem with active repeater electronics built into the cable. The electronics boost and regenerate the data signal along the run, allowing a dependable connection at 25 feet without the need for a separate hub or extender box between the two ends.
A USB cable has a maximum practical length before the signal degrades. Beyond that point, devices may disconnect, slow down or fail to enumerate. An active repeater cable is a simple way to cover a longer distance while keeping the cable itself as the only link in the chain. For many installations this avoids the extra cost, power supply and points of failure that come with separate extenders.
The Type-A male connector plugs into the host side, such as a computer USB port or a hub. The Type-B male connector plugs into the device, which is typically the square-shaped port found on printers, scanners, some external drives and many audio interfaces. Because both ends are male, this cable is a direct A-to-B link and should be used with devices and hosts that have the matching ports.
Plug the Type-A end into the computer or hub first, then connect the Type-B end to the device. Keep the cable clear of sharp bends and heavy loads, and avoid running it alongside mains power cables where possible. Check that the host port is a USB 3.0 port if you want full SuperSpeed performance, since a USB 2.0 port will limit the transfer rate.
Tripp Lite lists a 3-year limited warranty on this product. Keep proof of purchase and read the warranty terms supplied with the cable for conditions and claim procedures.
The Tripp Lite U328-025 is a practical choice when a USB 3.0 device needs to sit 25 feet from its host. Its active repeater design keeps the connection stable over that distance, and its A-B male-to-male layout suits the common printer, scanner and drive connections found in offices, schools and equipment rooms.



