





INFRASTRUCTURE TEAM
+27 (0) 11 237 1000
Eaton
9PX Gen2 Netpack 6000VA / 6000W, hardwired input, 3U rack/tower
Outputs: (6) C13, (6) C39, Gigabit network card included
The Eaton 9PX Gen2 Netpack 6000 VA / 6000 W is a high-capacity online UPS from Eaton’s 9PX Gen2 range. It is built to keep important IT equipment running through mains failures, brownouts and voltage spikes, and it provides clean, regulated power to the connected load at all times.
The unit is rated at 6000 VA and 6000 W and comes in a 3U form factor. It can be mounted in a 19-inch rack with the supplied rack-mounting kit, or used in a tower arrangement where rack space is not available.
As an online double-conversion UPS, the 9PX continuously supplies power to the load through its inverter, so connected equipment is isolated from mains disturbances. When the mains fails, the battery takes over without interruption, allowing servers to shut down safely or keep running until power returns. Adding external battery modules increases the available runtime, which is useful for sites with frequent outages or where longer backup is needed.
The included Gigabit network card allows the UPS to be monitored and managed over the network. This helps IT staff check battery status, load levels and events, and to arrange automatic shutdown of connected systems if the battery runs low.
The input is hardwired rather than plug-in, so the unit must be connected to the electrical supply by a qualified electrician. Plan the cabling and the location before installation, and allow for the external battery modules if they will be added later.
Eaton is a well-known supplier of power protection equipment, and the 9PX Gen2 series is aimed at businesses that need dependable, scalable backup power for their IT infrastructure.
Eaton
9PX Gen2 Netpack 6000VA / 6000W, hardwired input, 3U rack/tower
Outputs: (6) C13, (6) C39, Gigabit network card included
Share this on your favourite channel: