





INFRASTRUCTURE TEAM
+27 (0) 11 237 1000
Hikvision
24 Gigabit RJ45 + 4 Gigabit SFP ports, L2+ managed switch
Rackmount, stackable, non-PoE
The Hikvision DS-3E2528-HI-24T4F is a managed Ethernet switch designed to sit at the centre of a business or institutional network. With 24 Gigabit RJ45 ports and 4 Gigabit SFP fibre ports, it gives installers a flexible mix of copper and fibre connectivity in a single rackmount unit. It is part of the Hikvision networking range and is listed in the managed, non-PoE switch category.
Managed switches differ from the unmanaged switches often used in homes and small offices. Instead of simply passing traffic between ports, a managed switch lets the network administrator decide how traffic is handled. This DS-3E2528-HI-24T4F allows the administrator to set up virtual LANs, control traffic priority, enable loop protection and monitor the status of the network. These functions are useful when several departments, cameras, servers or wireless access points share the same infrastructure.
Network loops can cause serious slowdowns or outages if they are not controlled. The switch supports several spanning tree protocols, including RSTP, MSTP, PVST+ and RPVST+. These allow redundant links to be installed for backup while the switch blocks the paths that would create a loop. Choosing the right protocol depends on the existing network design, so the protocol used should match the rest of the network.
Routing allows traffic to move between different network segments. The switch supports RIP, OSPF and static routing, with up to 512 IPv4 routing entries. VLAN mapping and QinQ help separate traffic for different users, buildings or services. For example, a business can keep office computers, CCTV cameras and guest devices on separate logical networks while using the same physical switch.
When the network is busy, not all traffic is equally important. Quality of service settings based on strict priority, weighted round robin or a combination of both help ensure that critical traffic is handled first. Traffic shaping can limit the bandwidth available to specific ports or services, which helps prevent a single device from consuming all the capacity on a shared link.
The switch can be configured through its management interfaces, including SSH and a console port, and it supports SNMP v1, v2 and v3 for integration with network monitoring tools. Using SNMP v3 is recommended where security is important because it adds authentication and encryption. IGMP support helps control multicast traffic, which is common in video and streaming applications.
This switch suits a range of environments where managed, Gigabit connectivity is required:
As a rackmount switch, the unit should be installed in a standard 19-inch rack with adequate ventilation and cable management. Because it is non-PoE, devices that need power over the network, such as some cameras or access points, must be powered separately or connected to a PoE switch. Planning the VLAN layout and uplink design before installation will make configuration easier and help the network remain organised as it grows.
For the full specification sheet, configuration guidance or help choosing the right managed switch for a specific network, contact the shop before ordering.
Hikvision
24 Gigabit RJ45 + 4 Gigabit SFP ports, L2+ managed switch
Rackmount, stackable, non-PoE
Share this on your favourite channel:



