





INFRASTRUCTURE TEAM
+27 (0) 11 237 1000
Hikvision
L2 unmanaged PoE switch, 4 Gigabit PoE ports, 2 SFP uplinks
60W PoE power budget, DIN rail, -30 to 65°C operation
The Hikvision DS-3T0506HP-E/HS is a hardened Layer 2 unmanaged switch that combines four Gigabit PoE ports with two Gigabit SFP uplink ports. It is part of Hikvision’s unmanaged hardened switch range, designed for CCTV, wireless and industrial networks that need dependable power and data delivery in demanding environments. Because the switch is unmanaged, it installs quickly and runs without setup, making it practical for sites where a full managed switch would be more than the job requires.
Power over Ethernet allows a single cable to carry both data and electrical power to a connected device. This removes the need for a separate power supply at each camera, access point or sensor, which simplifies cabling and reduces installation cost. The DS-3T0506HP-E/HS supports the IEEE 802.3af, 802.3at and 802.3bt standards, so it can power a wide range of standard and higher-power PoE devices.
Many network switches are designed for clean, air-conditioned rooms. The hardened design of this switch allows it to function in environments with wide temperature swings, dust, vibration and electrical interference. The operating range from -30°C to 65°C makes it suitable for unheated outbuildings, roadside cabinets and industrial plant floors, where ordinary switches might fail. The 6kV surge protection adds a layer of defence against power spikes and lightning-related disturbances, which are common causes of network equipment damage at exposed sites.
Power distribution is a key consideration when planning a PoE network. With a total budget of 60W, the switch can support several standard PoE devices or a smaller number of high-power units. Port 1 is specifically rated for high-power PoE up to 60W, which makes it the right choice for a device with a heavier power demand, such as a pan-tilt-zoom camera or a high-output access point. The PoE watchdog is a useful safeguard: if a connected device stops responding, the switch can cycle its power, restoring the device without a site visit.
Ports 3 and 4 support runs of up to 300 metres, which extends coverage to cameras and devices placed well away from the switch cabinet. The two SFP slots accept fibre transceivers, allowing the switch to connect to a core network or another switch over long distances and to isolate the network from copper-related electrical problems. Port isolation prevents connected devices from communicating directly with each other, which improves security on a shared network segment, for example by keeping cameras from being reached by other devices on the same switch.
Mount the switch on a DIN rail inside a suitable enclosure to protect it from moisture and dust. Plan the PoE load so the total draw stays within the 60W budget, and place the highest-power device on port 1. Keep cable runs to ports 3 and 4 within the 300-metre rating, and use good-quality cabling and proper earthing to get the best results from the surge protection. Where a fibre link is needed, select SFP transceivers that match the distance and fibre type of your installation.
The Hikvision DS-3T0506HP-E/HS is a practical choice for installers who need reliable PoE networking in environments that would challenge standard equipment. Its combination of PoE power, fibre uplinks, hardened construction and simple operation makes it a sound option for both new installations and upgrades.
Hikvision
L2 unmanaged PoE switch, 4 Gigabit PoE ports, 2 SFP uplinks
60W PoE power budget, DIN rail, -30 to 65°C operation
Share this on your favourite channel: