





INFRASTRUCTURE TEAM
+27 (0) 11 237 1000
Hikvision
Pole mounting kit for 600mm wide MB enclosure
Article MBK-60
The Hikvision MBK-60 is a pole mounting kit made for the 600mm wide MB enclosure. Where a wall is not available, or where a camera system or network equipment must sit in the open on a post, this kit provides a practical way to secure the enclosure to a pole. It is part of the Hikvision IP Video accessories range and is designed to be used alongside Hikvision IP video equipment.
Security installers often face sites with no convenient wall for mounting. Long driveways, car parks, gate areas, perimeter fences and open yards are typical examples. In these locations a pole gives a stable, elevated base for the enclosure, which keeps the housed equipment above ground level and away from casual contact. The MBK-60 is intended to make this type of installation straightforward by providing a dedicated kit matched to the 600mm wide enclosure.
The MBK-60 is most useful in the following situations:
A good installation starts with planning. Measure the available pole and check that it is solid, upright and able to carry the weight of the enclosure and its contents. Confirm the enclosure is the 600mm wide MB model, because the kit is made for that size. Plan the position of the enclosure so that cameras or other equipment have an unobstructed view, and so that cable entry points face away from the weather where possible.
Route cables carefully. Leave a small service loop so that the enclosure can be opened for maintenance without strain on connectors. Use suitable cable glands or entry points for outdoor work, and seal all openings to keep out dust, insects and moisture. Where the pole stands in a vehicle area, consider the risk of impact and place the pole at a sensible distance from traffic.
Because the MBK-60 is an accessory, it should be ordered with the correct enclosure. Check the pole diameter and the mounting method against the instructions supplied with the Hikvision product, and confirm the fittings suit the site. If your project involves a specific pole type or unusual mounting height, ask your supplier to confirm compatibility before the job is started.
Using a kit designed for the enclosure saves time on site. Improvised brackets can shift under wind load, misalign the enclosure and expose cables to damage. A matched kit helps the enclosure sit square, keeps the installation looking professional and reduces the number of visits needed to correct problems later.
The MBK-60 is therefore a sensible choice for installers who need a reliable way to put a 600mm wide MB enclosure on a pole, whether for a single camera point or a larger outdoor security layout.
Hikvision
Pole mounting kit for 600mm wide MB enclosure
Article MBK-60
Share this on your favourite channel: