





INFRASTRUCTURE TEAM
+27 (0) 11 237 1000
Hikvision SFP module, 1.25G
TX 1310nm / RX 1310nm, LC duplex, multimode fiber, up to 1km
Operating temperature 0 to 70°C

The HK-SFP-1.25G-1310-DF-MM is an SFP fiber optic transceiver module from the Hikvision networking range. It is built for 1.25 Gigabit data links over duplex multimode fiber with an LC connector. The module uses a 1310nm wavelength for both transmit (TX) and receive (RX), and it is rated for up to 1km of fiber and an operating temperature of 0 to 70°C.
In practice, an SFP module is the bridge between a network device and an optical fiber. The module slides into a compatible SFP cage on a switch, router or media converter. The fiber patch lead then connects to the LC duplex socket on the module. Once both ends of the link are installed, the equipment handles the signal and the link is available for network traffic.
Fiber links avoid many of the limits of copper cabling. They carry data over longer distances, they are not affected by electrical interference from motors, lifts or power cables, and they keep electrical potential differences out of the connection. A pluggable module adds flexibility: the same switch port can support different optical types as the network changes, and a fault can be fixed by swapping one small part instead of re-terminating cables.
Because the module is designed for 1.25G links over multimode fiber, it fits a range of practical network roles. In a surveillance installation it can carry traffic from a switch in a remote building back to the main network video recorder room. In an access control network it can link a switch at a gate or entrance to the head-end system. Within a single site it can form a backbone between two equipment cabinets, or connect a distant switch where a copper run would exceed the supported length or pass through an area with interference.
Before installing, confirm that the SFP port on the switch or device supports 1.25G modules and that the fiber cable is multimode with an LC duplex termination. Both ends of the link must use compatible wavelengths, which here is 1310nm. Keep the fiber connectors clean and capped when not in use, since dust is the most common cause of poor optical performance. Insert the module until it clicks into place, and use the correct duplex patch lead, making sure transmit and receive are crossed correctly between the two ends.
Check that the module suits the device it will be fitted to, including the port speed and any vendor requirements of that equipment. Plan the cable route so that the total fiber distance stays within the rated range of up to 1km. If the operating environment is hotter or colder than the stated 0 to 70°C range, consider a different module or additional cabinet cooling. For larger projects, record the module type and fiber route in the network documentation so future maintenance is quicker.
The HK-SFP-1.25G-1310-DF-MM is a practical, pluggable fiber module for 1.25G multimode links up to 1km. It suits networking installations that need reliable fiber connections between switches and remote devices, and it makes maintenance simple because a failed module can be replaced without changing the cabling.
Hikvision SFP module, 1.25G
TX 1310nm / RX 1310nm, LC duplex, multimode fiber, up to 1km
Operating temperature 0 to 70°C
Share this on your favourite channel: