





INFRASTRUCTURE TEAM
+27 (0) 11 237 1000
Molex
12 Fiber Singlemode G.657a2 Duplex LC Blue
Bend-insensitive singlemode fibre with duplex LC connectors
The Molex 12 Fiber Singlemode G.657a2 Duplex LC Blue is a singlemode fibre product from the Molex range of copper and fibre structured-cabling components. It is designed for installers and network designers who need dependable fibre links between switches, patch panels, enclosures and backbone points in offices, campuses, data rooms and commercial buildings.
Singlemode fibre carries light through a very small core, so a single light path can travel long distances with low loss and high capacity. This makes it suitable for links where multimode fibre would be limited by distance, and for installations that must support faster network speeds in the future without replacing the cable.
G.657 is an ITU-T specification for bend-insensitive singlemode fibre. Category A2 describes fibre that keeps its performance when bent more tightly than standard singlemode fibre. In a real installation this matters where cables pass through tight cabinet corners, cable management arms, ceiling spaces and wall boxes. Bend tolerance reduces the risk of signal loss caused by rough routing, and it gives installers more freedom when planning cable paths.
An LC connector is a small push-pull connector with a 1.25 mm ferrule. A duplex LC connector joins two fibres, one for transmit and one for receive, in a single clip-together unit. This arrangement is the common choice for network equipment, transceivers and fibre patch panels. Its small footprint allows more ports in the same rack space, which is useful in equipment rooms where space is limited.
Good fibre installation depends on careful handling. Avoid sharp bends below the minimum bend radius specified for the cable, even though G.657.A2 fibre is bend-tolerant. Keep dust caps on connectors until the moment of mating, and clean end faces with approved fibre cleaning tools before connection. Dirty connectors are one of the most common causes of fibre link faults, so a simple cleaning step before each connection is worthwhile.
Label both ends of each link during installation. Duplex LC connectors are easy to confuse when several links are bundled together, so a clear label at each termination point saves time during testing and future maintenance. Keep a record of the route, length and connector type so that future changes can be planned without guesswork.
Before ordering, confirm the required number of fibres, connector type and cable jacket for the installation. Check that the fibre type matches the transceivers or equipment at each end of the link. Where the installation is part of a wider Molex system, use Molex panels, adapters and enclosures so that the components are designed to fit together. For exact specifications, such as attenuation, bend radius, jacket rating and connector finish, refer to the Molex datasheet for the specific part.
The blue finish helps identify singlemode links at a glance. Many installers use colour coding to separate singlemode from multimode links, which reduces mistakes when connecting equipment during commissioning and later changes.
The Molex 12 Fiber Singlemode G.657a2 Duplex LC Blue suits structured-cabling projects that need long-distance, high-capacity fibre links with bend-tolerant routing and standard LC connectivity. It is a practical choice for backbone, distribution and equipment connections where reliability and future growth are priorities.
Molex
12 Fiber Singlemode G.657a2 Duplex LC Blue
Bend-insensitive singlemode fibre with duplex LC connectors
Share this on your favourite channel: