





INFRASTRUCTURE TEAM
+27 (0) 11 237 1000
Molex
12 Fiber Singlemode G.657a2, Duplex SC APC connectors, Green
Molex fibre assembly for singlemode structured cabling
The Molex 12 Fiber Singlemode G.657a2 Duplex SC APC Green is a singlemode fibre assembly from Molex’s copper and fibre structured-cabling range. It is intended for network links that need the long reach and high bandwidth of singlemode fibre, such as backbone connections between buildings, rooms and cabinets.
Structured cabling projects often combine copper and fibre, and Molex supplies both in matching families. This product brings the fibre side of that system into a single, ready-to-use assembly, with the connector type and polish already chosen for you.
Singlemode fibre carries a single light path, which allows much longer distances and higher capacity than multimode fibre. The G.657.A2 designation describes a fibre that tolerates tighter bend radii than standard singlemode. In practice this means the cable can be routed through congested trays, rear-of-rack spaces and wall boxes with less risk of attenuation.
The duplex SC format uses two connectors, one for transmit and one for receive, joined in a single housing. SC connectors use a push-pull latch that is quick to mate and remove, which suits frequent changes in patch panels. The APC polish is angled at a small angle, which sends back-reflected light away from the core. This matters on networks where reflections can disturb the laser source, particularly in higher-speed or analogue systems.
Installers typically use assemblies like this to make final connections at panels and cabinets, while the longer cable run is pulled and terminated separately. Because the connectors arrive factory-terminated, the job is quicker and avoids on-site polishing.
Keep the connector end faces clean and covered until they are mated. Dust on a fibre end face is one of the most common causes of poor signal quality. Avoid tight bends below the cable’s minimum bend radius, even though G.657.A2 fibre tolerates tighter bends than standard singlemode. Match the APC connectors to APC adapters only, because mixing APC and UPC connectors can damage the end faces and degrade the link.
Check the cable and connector type against the equipment and panels in your installation before ordering. Confirm the fibre count and connector format fit the ports you plan to use.
For further details on this part, refer to the Molex datasheet for the relevant fibre family.
Molex
12 Fiber Singlemode G.657a2, Duplex SC APC connectors, Green
Molex fibre assembly for singlemode structured cabling
Share this on your favourite channel: