





INFRASTRUCTURE TEAM
+27 (0) 11 237 1000
Molex
24 fibre singlemode, G.657.A2 bend-insensitive fibre
Quad LC APC connectors, green, low loss

The Molex 24 Fiber Singlemode G.657a2 Quad LC APC Green Low Loss is a high-density singlemode fibre optic assembly designed for backbone and distribution links in structured cabling. It combines twenty-four singlemode fibres, bend-insensitive G.657.A2 fibre, quad LC connectors with angled physical contact (APC) polishing and a low-loss construction in one product. It belongs to the Molex fibre range, which is designed to work with Molex copper and fibre panels, cassettes and enclosures.
Singlemode fibre carries light over long distances with very little dispersion. It is the right medium for links that run between buildings, between network rooms on a campus, or from a central distribution point to remote areas. Compared with multimode fibre, singlemode is used where distance and bandwidth headroom are the main concerns, and this assembly is built for that role.
The fibre designation G.657.A2 refers to the ITU-T classification for bend-insensitive singlemode fibre. Compared with standard singlemode fibre, it keeps signal loss lower when cables are bent around corners, through cable managers or inside tight cabinet spaces. This is valuable in dense installations where patch routes are short and bends are frequent.
APC connectors have an eight-degree angled end face. The angle sends back-reflected light out of the core, which reduces return loss problems in sensitive optical systems. The green colour is the normal marking for APC, and it is a practical identifier: APC connectors must only be mated with other APC connectors. Mating an APC connector to a UPC (flat-polished) connector creates a high-loss joint and can damage the ferrules, so installers should check colour and type before connecting.
The quad LC arrangement packs four LC duplex pairs into one assembly. LC connectors are small, so quad arrangements suit high-density fibre panels where space is limited. Technicians can identify individual fibre pairs during testing and maintenance, and the arrangement lets a single assembly serve several equipment ports.
This assembly is typically used in:
Good installation practice protects the performance of singlemode links. Keep bend radius above the manufacturer’s minimum, avoid pulling the assembly by its cable, and keep connector end faces clean and covered until mating. Use only compatible APC connectors at each end, and test the completed link with appropriate optical test equipment. Because the product is a structured-cabling component, its suitability for a given route should be confirmed against the route length, panel type and equipment interface.
The listing describes the assembly by its fibre count, fibre type, connector configuration, polish and colour. Buyers who need a specific length, jacket rating or connector arrangement should check the Molex datasheet for the part before ordering, so the assembly matches the intended route and equipment.
Molex
24 fibre singlemode, G.657.A2 bend-insensitive fibre
Quad LC APC connectors, green, low loss
Share this on your favourite channel: