





INFRASTRUCTURE TEAM
+27 (0) 11 237 1000
Molex
24 Fiber Singlemode, G.657a2, Quad LC connector, Blue
Fibre optic singlemode structured cabling part
The Molex 24 Fiber Singlemode G.657a2 Quad LC Blue is a fibre optic assembly designed for structured cabling in offices, data rooms and networked buildings. It combines 24 singlemode fibres, a G.657.A2 bend-insensitive fibre type, and Quad LC connectors in a blue finish. It belongs to the Molex datasheet range of copper and fibre connectivity products, which are intended to be installed as part of a complete, planned cabling system.
Singlemode fibre has a very small core, so only one light path travels through it. This allows signals to cover long distances with low loss, which is why it is used for backbone links, inter-building connections and campus networks. The G.657.A2 category adds bend tolerance, meaning the fibre can be routed around corners and through tight spaces without the same degree of signal loss that older singlemode fibre would suffer. In practice this makes installation in cabinets, cable managers and wall boxes easier, especially where many cables share the same space.
LC is a small form-factor connector widely used on modern fibre panels and transceivers. Quad LC arrangements group several LC terminations into one connector body, which saves space on the panel and simplifies the handling of many fibres at once. This is useful in high-density patch panels, where the number of ports per rack unit is an important design consideration.
Before installing, confirm the connector type, fibre count and polarity scheme against your panel or enclosure. Plan the cable route so that the bend-insensitive fibre is not forced into tighter radii than necessary, and leave enough slack for future maintenance. Keep fibres clean and protected until they are connected, because dust and scratches on connector end faces are a common cause of link problems. Label both ends clearly, using the blue jacket colour as part of your standard labelling scheme.
Choose this assembly when your project calls for singlemode fibre, high fibre density and a bend-insensitive cable type. If your link is short and uses lower-cost optics, multimode fibre may be more appropriate. For long-distance or backbone work, singlemode is generally the better choice. Check the product datasheet from Molex for the complete specification before finalising your design, and make sure any active equipment you connect supports singlemode optics.
Molex
24 Fiber Singlemode, G.657a2, Quad LC connector, Blue
Fibre optic singlemode structured cabling part
Share this on your favourite channel: