





INFRASTRUCTURE TEAM
+27 (0) 11 237 1000
Molex
24-fibre OM3 multimode fibre optic cable, PE insulated, black
CST double sheath offering, structured cabling
The Molex 24-fibre OM3 multimode fibre optic cable is a structured cabling component for building and campus networks. It is a black PE insulated cable from the CST double sheath offering in the Molex datasheet range. Installers use it as a fibre backbone or horizontal link between network equipment, patch panels and distribution points, where the 24 fibres in a single cable make efficient use of installation time and cable pathways.
The cable is supplied as a Molex part within the Molex structured cabling family, so it is designed to work with the wider Molex range of fibre enclosures, cassettes, adapters and patch leads. Matching components from one range help keep a system consistent and simplify testing and documentation.
Multimode fibre has a larger core than singlemode fibre, which allows light to travel along several paths at once. This suits shorter distances inside buildings and campuses, and makes equipment such as transceivers and media converters easier to use. OM3 is an optimised multimode grade that supports higher data rates over typical premises link lengths than older multimode grades. Selecting OM3 means the cable should work with equipment built for that grade, but the exact supported speeds and distances depend on the application and the datasheet should be checked for the figures that apply.
The black PE insulation provides a general-purpose outer finish. The product description does not state the fire rating, minimum bend radius, pulling tension, temperature range or whether the cable is suitable for ducts, risers or outdoor runs. These details matter for installation planning, so the datasheet should be consulted before the cable is routed through plenums, ceilings or external ducting. The CST naming refers to the Molex sheath offering and the datasheet will confirm the construction.
Fibre cable of this type is normally terminated with suitable connectors in a fibre enclosure or patch panel. Splice trays and cassettes help organise the fibres and protect the splices. Testing equipment, such as an optical loss tester or OTDR, is used to verify each link after termination. Planning the layout of the cable route, leaving slack at each end and labelling both ends of every fibre will make future changes and maintenance much simpler.
Confirm the fibre count, the OM3 grade and the sheath type against the design before ordering. Check the datasheet for the detailed specifications, including fire rating and mechanical limits. Ordering the correct cable length with a small allowance for routing and termination will avoid waste and delays on site.
Molex
24-fibre OM3 multimode fibre optic cable, PE insulated, black
CST double sheath offering, structured cabling
Share this on your favourite channel: