





INFRASTRUCTURE TEAM
+27 (0) 11 237 1000
MOLEX
6 core singlemode OS2 fibre, loose tube, PE insulated
Black, for internal and external use
The MOLEX 6 core singlemode OS2 fibre optic cable is a structured-cabling product for building fibre backbones and links between network points. It carries six singlemode fibres in a loose tube construction, enclosed in a black PE (polyethylene) outer sheath. The cable is suited to both internal and external use, which gives installers flexibility when a route starts inside a building and continues outdoors, or the reverse.
Fibre optic cable carries data as pulses of light rather than electrical signals. Singlemode fibre has a very small core that allows a single light path, which reduces signal dispersion over distance. OS2 is the standard designation for low-loss singlemode fibre used in premises and outside plant. For a network planner, this means the cable is suited to longer runs and to high-bandwidth links where capacity may need to grow later without replacing the cable.
The exact dimensions, bend radius, pulling load, attenuation values and temperature ratings are set out in the Molex datasheet for this part. Check the datasheet before specifying the cable for a particular route or environment.
The loose tube design keeps the fibres free to move within their tubes. This helps protect them from the stresses that come with temperature changes, ground movement and cable handling, which is why loose tube cable is often chosen for outdoor and underground routes. The PE sheath adds a tough outer layer that resists abrasion and moisture during installation and service.
The black colour is standard for outdoor-rated polyethylene jackets and helps identify the cable type during installation and maintenance. Because the cable is rated for both internal and external use, a single cable type can often be used across a site rather than stocking separate indoor and outdoor products.
Fibre cable should be installed by trained cabling technicians. Plan the route, allow for slack at termination points and observe the minimum bend radius given in the datasheet. Fibres must be terminated or spliced with suitable connectors, splice trays or enclosures that match the six-fibre count and the connector type used in the network. Testing after installation is recommended to confirm link performance.
Store cable on reels or in coils away from heat and sunlight until it is needed, and keep ends sealed to protect the fibres from dust and moisture. Handle the cable gently and avoid kinking or crushing it during pulling.
Choose a 6 core singlemode OS2 cable when the link is long, the bandwidth need is high, or the route runs between buildings. Choose multimode fibre instead when the link is short and inside one building and the equipment supports it. Confirm the connector type, the enclosure and the patch panels before ordering so that the whole fibre path works together.
MOLEX
6 core singlemode OS2 fibre, loose tube, PE insulated
Black, for internal and external use
Share this on your favourite channel:



