





INFRASTRUCTURE TEAM
+27 (0) 11 237 1000
MOLEX
8 Core Singlemode OS2, Loose Tube, PE Sheath, Black
Int/Ext: suitable for indoor and outdoor use per supplier description
The Molex 8 Core Singlemode OS2 Fibre Optic Cable is a fibre optic cable for structured network cabling. It contains eight singlemode fibres and is classed as OS2, the singlemode grade used for longer distance links and high bandwidth backbones. Molex is a well-known name in structured cabling, and this cable is listed in its fibre range for installers who need a reliable backbone between network points.
Singlemode fibre carries a single light path through a very small core. This allows signals to travel much further than multimode fibre before they need regeneration, which makes OS2 singlemode the normal choice for campus links, building-to-building connections and long backbone runs. The eight-core count lets one cable carry several separate links, so a single run can serve multiple switches or distribution points.
For exact figures such as attenuation, maximum tensile load, minimum bend radius, outer diameter and weight, refer to the Molex product datasheet. These values depend on the exact part and should be confirmed before design work begins.
In a loose tube cable, the fibres lie inside one or more buffer tubes that are filled with a gel or water-blocking material in many designs. The tubes can move slightly inside the jacket, which reduces the strain placed on the glass when the cable is pulled, bent or exposed to temperature changes. This design is commonly used for outside plant work, where cables face more stress than in a building riser.
The Int/Ext description means the cable can be run through building entries and then continue outdoors, which saves the cost of changing cable at the building boundary. Always follow the installation guidance in the datasheet, including minimum bend radius during pulling and the correct method for entering a building.
Plan the route before ordering, measuring the length with a margin for slack, joints and termination. Keep the cable away from sharp edges and heavy loads, and never exceed the pulling tension given in the datasheet. Use a clean, dry work area when preparing the fibres, and protect ends with caps until connectors are fitted.
Terminate the fibres with connectors matched to your transceivers and patch panels. Singlemode connectors need careful polishing and cleaning, as dust on the end face is a common cause of signal loss. Test each link after installation with an optical power meter or OTDR so that faults are found before the network is brought into service.
This product suits network installers, structured cabling contractors and IT teams who are building or upgrading a fibre backbone. It is best matched to projects that already use singlemode equipment, or that plan to move to higher speeds over longer distances in the future. If your project uses multimode equipment, a multimode cable would be the better fit.
Order with matching Molex or compatible singlemode connectors, splice trays, patch panels and fibre enclosures to keep the installation complete. If you are unsure which core count, jacket or rating your installation needs, confirm the requirements with the design or the Molex datasheet before ordering.
MOLEX
8 Core Singlemode OS2, Loose Tube, PE Sheath, Black
Int/Ext: suitable for indoor and outdoor use per supplier description
Share this on your favourite channel:



