





INFRASTRUCTURE TEAM
+27 (0) 11 237 1000
Molex
Cat6A shielded LSZH patch cord, 568A/B wiring, 15m length
Part PCD-07014-0* (colour variant)
The Molex PCD-07014-0* is a 15 metre Category 6A patch cord designed for use in structured cabling systems. It is a patch lead, meaning it is used to make short, flexible connections between the fixed cabling in a building and the active equipment that runs the network. Whether you are patching a switch in a comms cabinet or connecting a workstation to a wall outlet, this cord provides a dependable copper link.
Patch leads like this one are used at the ends of a cabling run. The permanent cable is installed in walls, ceilings and trunking, terminated on a patch panel or outlet, and then the patch cord bridges the gap to the device. Because the patch cord is handled and moved often, its construction and jacket matter as much as its electrical performance.
Category 6A is the copper standard built for higher data rates than the older Cat5e and Cat6 standards. Cables and patch cords in this category are designed with tighter control over crosstalk and noise, which is important when several pairs run close together in a busy network. Shielding adds a further layer of protection in environments with many power cables, lighting circuits or industrial equipment nearby.
LSZH stands for low smoke zero halogen. When this type of sheath burns, it releases much less smoke and does not give off the corrosive halogen gases produced by some standard PVC jackets. For this reason, LSZH cabling is often specified for public buildings, offices with many people, schools, hospitals and enclosed spaces where people need to escape or where equipment is sensitive to corrosion.
The cord is terminated to the 568A/B wiring pattern. These are the two accepted colour-code arrangements for RJ45 connectors in Ethernet cabling. Using a consistent pattern across the installation helps ensure that patch cords, panels and outlets match, which makes testing and fault-finding simpler.
A 15 metre patch cord gives extra reach when the equipment is not close to the patch panel or outlet. It is useful in larger cabinets, where the cord has to route around other cables, or where a desk or device sits further from the wall. Keep in mind that longer patch cords can create slack, so route and secure them neatly to avoid tangles and to keep the cable bend radius within acceptable limits.
Handle patch cords by the connector rather than pulling on the cable. Avoid tight bends near the connectors and do not kink the cord. Label each end so that the cord can be identified later, and keep patch cords for different systems visually separate where possible. Where colour variants are used, a consistent colour scheme makes it easier to see which links are for data, voice, wireless or cameras.
If you are unsure whether this length, shielding or colour is right for your installation, check the requirements of the network equipment and the existing cabling before ordering. A quick check at the planning stage can prevent a stock order of the wrong colour or length later on.
Molex
Cat6A shielded LSZH patch cord, 568A/B wiring, 15m length
Part PCD-07014-0* (colour variant)
Share this on your favourite channel: