





INFRASTRUCTURE TEAM
+27 (0) 11 237 1000
Molex
CAT6A termination head for the Molex crimp tool range
Part of the C5e and C6 CAT6A crimp tool and head set
The Molex CAT6A termination head is a replacement head for the Molex crimp tool, sold as part of the Molex extras range for structured copper cabling. It is intended for installers who terminate Molex copper connectivity and need the correct head for CAT6A work. The product sits within the crimp tool and head set listed for C5e and C6 CAT6A, which shows that it is designed to be used with the wider Molex crimp tool system rather than as a standalone item.
Structured cabling relies on careful termination at every outlet and patch panel. A poorly seated or damaged termination can lead to faults that are difficult to trace once the cabling is installed behind walls or in ceilings. For this reason, many installers keep the correct tool heads close to hand and replace them as soon as they show wear. The Molex CAT6A termination head gives you a dedicated part for this task, so you can maintain the same tooling standard across a project.
A termination head is the working end of a crimp tool. It is the part that makes contact with the connector and cable during termination, so it is shaped and matched to a specific connector family. The CAT6A head is therefore not interchangeable with heads for other categories or systems. Choosing the head that matches your cable category and tool is the first step to a reliable termination.
The Molex CAT6A termination head is used in the following situations:
This head is most useful for network cabling installers, electrical and data contractors, and in-house IT or facilities teams who carry out structured cabling work. It is particularly relevant to anyone already working with Molex CAT6A components, since the head is designed to match that system. If you are new to Molex termination, it is worth reviewing the tool set and the cable category before you buy, so that you order the correct head.
Before ordering, check the following:
If you are unsure whether the head fits a particular tool version, it is sensible to check with your supplier before placing an order. Keeping the correct part number and the existing tool details to hand will make this check quick.
Like any precision tool part, the termination head should be kept clean and stored in a dry place when not in use. Avoid dropping it onto hard surfaces, as this can damage the working faces and affect termination quality. Regular inspection before each job helps you spot wear early, and replacing a worn head is usually far cheaper than re-terminating a faulty installation.
Molex
CAT6A termination head for the Molex crimp tool range
Part of the C5e and C6 CAT6A crimp tool and head set
Share this on your favourite channel: