





INFRASTRUCTURE TEAM
+27 (0) 11 237 1000
MOLEX
Datagate 4 pair termination tool frame, supplied unloaded
Use the matching termination heads listed separately

The Molex Datagate 4 Pair Termination Tool Frame is a specialised termination tool for installers working with the Molex Datagate copper connectivity system. It forms part of the Molex crimp tool and head range for Cat6 and Cat6A installations. The frame is supplied unloaded, so it is the body of the tool only, and it is intended to be used together with the matching termination heads.
Structured cabling depends on consistent terminations. Each cable pair must be seated correctly in the connector, and the cable jacket must be controlled up to the point of termination. A purpose-built frame and head combination helps the installer achieve a neat, repeatable result across a whole rack or wall outlet run, which matters for both performance and tidy presentation.
The supplier description states that the tool is unloaded and that the heads should be used from the list provided. Before ordering, confirm that you have the correct head for your Datagate module or termination type. Ordering the frame alone will not give you a working tool until a compatible head is added.
Network installers and structured-cabling technicians use this kind of termination frame for the following work:
Using the correct tool for a connector system reduces the risk of poor terminations, which can cause intermittent faults or reduced network performance. A tool made for the Molex range is designed to match the dimensions and geometry of the connectors, so each termination is seated the way the system expects. This supports the performance that the wider Molex copper system is designed to deliver.
Store the frame in a clean, dry location, away from dust and moisture. Inspect the frame and the head before each job, and replace any worn parts rather than forcing a termination. Keeping the tool in good condition helps maintain clean, consistent work over a long service life.
This frame suits installers who already work with Molex copper components and need a reliable termination tool for their projects. It is equally useful for contractors who maintain existing networks, as it lets them match new terminations to the original Molex hardware.
If you are unsure which head to use with this frame, check the matching head listing or ask a product specialist before purchase, so the tool and the connectivity components work together correctly on site.
MOLEX
Datagate 4 pair termination tool frame, supplied unloaded
Use the matching termination heads listed separately
Share this on your favourite channel: