





INFRASTRUCTURE TEAM
+27 (0) 11 237 1000
Molex
Euromod IP66 2 x RJ45 enclosure, unloaded, grey
Outdoor Cat 6A range, sold as a pack of 2

The Molex Euromod IP66 2 x RJ45 Enclosure Unloaded Grey is a weather-resistant housing for two RJ45 network outlets. It belongs to the Molex CAT 6A IP66 outdoor connectivity range, which is built for structured cabling that has to work outside the building or in harsh indoor environments. The product is sold as a cost for a pack of two enclosures, so one purchase covers two separate points.
The enclosure is delivered unloaded. This means that no outlets, keystone jacks or Euromod modules are fitted at the factory. The housing gives you the protected body and the mounting position, and the installer adds the chosen connectivity inside it. This approach lets the same enclosure be used with different module types and cable terminations, depending on the job.
IP66 is a standard rating that sets out how well an enclosure keeps out solid particles and liquids. The first digit refers to protection against dust, and the second digit refers to protection against powerful water jets. In practice, an IP66 housing is intended to keep rain, hosed-down surfaces and airborne dust away from the connectors inside. This matters for network points, because moisture and dirt are common causes of poor signal quality and intermittent faults. Installers should still fit the enclosure correctly, use proper cable glands or entry points and seal all openings, since the rating only applies when the housing is assembled as designed.
Network points placed outside a building are exposed to sunlight, temperature changes, rain, wind and dust. A standard plastic back box fitted indoors can crack, let water in or allow insects to enter. An IP66 enclosure provides a more robust solution for these conditions. It also keeps the connectors tidy and protected, which reduces maintenance visits and helps the installation last longer.
Before ordering, decide how many outlets you need at each point and which modules you will fit. Because the enclosure is unloaded, you must buy the outlets, jacks or Euromod modules separately and check that they suit the enclosure. Cable entry should be planned so that the cable enters from below or from the side where possible, which helps keep water from running into the housing. Use a suitable cable gland or sealing method for each entry point, and leave enough cable slack for future service work.
The two-pack format is practical for projects that need several outdoor network points, such as a perimeter with multiple cameras or a site with more than one external building. Buying in pairs also gives spare capacity for future expansion or replacement. Keep the second enclosure in stock if the site has a high exposure to weather, as a spare can speed up repairs.
Confirm that the Euromod modules and outlets you plan to use are compatible with this enclosure. Check the mounting method and available space for the cabling. If the point will be used for high-powered devices or a specific standard, review the technical details for the chosen module and cabling system so that the whole channel meets the required specification. The enclosure itself is a housing; the performance of the link depends on the complete installation.
In short, the Molex Euromod IP66 2 x RJ45 Enclosure Unloaded Grey gives installers a weather-protected base for two network outlets, sold in a practical pack of two. It is a suitable choice for outdoor and harsh-environment network points where a standard indoor back box would not provide enough protection.
Molex
Euromod IP66 2 x RJ45 enclosure, unloaded, grey
Outdoor Cat 6A range, sold as a pack of 2
Share this on your favourite channel: